just follow the top radiator hose until it goes into the block your thermostat it in there, just remove the two bolts, and be sure to put it in correctly.AnswerSome were conveniently placed right under the radiator cap. 1992 4 cylinder
To replace the thermostat on a 91 Cavalier you need to drain the radiator. Remove the top radiator hose and water inlet. Remove the thermostat from under the inlet. Install the new thermostat and reinstall the inlet and hose. Fill the radiator with fresh antifreeze.
Behind the glove compartment.
I have a 93 Chevy Beretta and mine is located INSIDE my fuel tank so I would look there. in the fuel tank
You don't. A 1991 Cavalier did not come with airbags.
at or near the thermostat housing
If it has a 4.3L engine the temp sensor is located next to the thermostat housing.
there is none its controled by the tps sensor located on the pleteum
The thermostat on a 1991 Buick Skylark is located near the engine. To find the thermostat, follow the top radiator hose directly to the thermostat.
Behind the glove box.
usually located up by the steering column. It should be a round tin/aluminim fuse. Just pull it out and replace.
You can find the 1991 Dodge Shadow thermostat in the thermostat housing. The thermostat housing will be on the front of the engine.
You don't, you replace it.
Check the fuse box.
Around 2300-2500 lbs
Chevy dealer, auto parts store, etc.
Look where the upper radiator hose connects to the engine. You will find the thermostat housing near that location. The thermostat may be inside the housing where the hose connects.
Where is the horn located on a 1993 chevy blazer
No Belt=It has a Timing Chain.=
On the right side of the fuse box
The refrigerant capacity of a 1991 Chevrolet Cavalier is 36 ounces of R-12 Freon. This is the same for all Cavaliers produced from 1986 to 1993.
Was built for R12, should be converted to R134a
There is'nt one on the guage cluster but there is on the motor up by the thermostat housing
Just follow the top radiator hose to the engine, and it will clamp onto the thermostat housing. Remove those two bolts and it will be right there.MAKE SURE ENGINE IS COLD