0
Follow the upper radiator hose to the engine. Should be right there. the answer here is incorrect... the thermostat is near the water pump in the housing close to the lower hose...
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Thermostat location on 93 Toyota Camry Vienta?
On a 1993 Toyota Camry Vienta, the thermostat can be easily located by following the lower radiator hose to the point where it attaches to the engine. When replacing the thermostat, always replace gaskets as well.
Where is the ignition fuse located for a 1993 Toyota Camry?
The 1993 Toyota Camry ignition fuse is located in the fuse box. The ignition fuse will be in the first column, fourth from the top.
How do you change the thermostat in 1993 Toyota Camry?
Put it on jack and take the tires off then search on internet
What temperatue rating of the thermostat is best to use in 1993 Toyota Camry 2.2ltr?
180 degrees F.
Where is the ignition module located on 1993 Toyota Camry?
where is the fuel located for ignition what number of the fuel
Where is thermostat on 93 Toyota Celica?
The thermostat on a 1993 Toyota Celica can be found by following the outlet radiator hose. The thermostat on these cars are located at the bottom of the radiator.
Where is the fuel pump located on a 1993 Toyota Camry 6 cylinder?
In the fuel tank
Where do you drain antifreeze in a 1993 Toyota Camry?
From the drain plug located at the bottom of the radatior
Were is 1993 Toyota Camry fuel-filter located?
93 Camry fuel filter is right below the brake master cylinder
What is code 21 for 1993 Camry?
what is a code 21 on 1993 Toyota Camry 4cyl
Where is the transmission speed sensor located on 1993 Toyota Camry 2.2L?
On top of transmission, drivers side.
How do you replace the thermostat located on a 1993 Toyota Camry 4 cylinder?
my 1993 Toyota Camry radiator had a hole in it it was overheating. I replaced the radiator. The car is still overheating where is the thermostat located. First, drain your coolant from the radiator. Find your lower radiator hose and follow it to the metal housing. This is the thermostat housing. Remove the 2 nuts with a 10mm wrench. Remove the thermostat and replace with new one and new gasket. Re-install and re-fill your radiator with new coolant. Drive the car with heater running. Allow the engine to cool and top off the radiator. Add coolant to the reservoir to halfway between Full and Low.
