answersLogoWhite

0


Best Answer

it is on the fron of the intake where the top radiator hose goes u take the hose of then there will e 2 bolts holding the thermostat housing(thing that the hose goes to) on take them off and u will find the thermostat

AnswerI am pretty sure the thermostat is at the end of the upper rad hose where it enters the top of the engine. At 14 I worked a summer job at an autowreckers, at 15 I tore motors of all kinds apart with a friend of my moms and I rebuilt my first Chevy smallblock, a 283 c.i. when I was 16, now at 45 and with many many Chevy's under my belt as far as I know gm has almost always located its thermostats in this area. two bolts and pop the housing should be a simple answer.
User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the thermostat located on a 1996 Chevy S-10?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the headlight relay located on a 1996 Chevy S10?

It is built into the headlight switch.


1996 Chevy s10 fuse box diagram?

The fuse box diagram for a 1996 Chevy S10 is located on the back of the panel cover. It identifies the location of each fuse and its use.


Where is evap canister located on a 1996 Chevy s10 blazer?

Where is evap canister located on a 1996 chevy s10 blazer? It should be found above the rear axle on the drivers side, mounted to the inside of the frame rail.


Where is the fuelpump located on A 1996 Chevy S10 4cy 2WD?

It is inside of the fuel tank.


Were is the voltage regulator located on a 1996 Chevy s10 4.3 liter?

It is built into the alternator.


Where is the temperature sensor in 1991 Chevy S10?

If it has a 4.3L engine the temp sensor is located next to the thermostat housing.


Where is starter on 1996 Chevy S10 4 cylinder and how difficult it to replace?

The started on a 1996 Chevy S10 4 cylinder is located under the battery and to the right. With the right tools and time it is not hard to replace.Ê


Where is the water temperature sensor located on a 1996 Chevy S10 4.3 6 cylinder?

The sensor for the temp gauge in the 96 S10 4.3L would be the sensor located between #3 and #5 spark plugs, it has one wire plugged to it. The temp sensor for the ECM is located next to the thermostat housing, it has two wires plugged to it.


Is a 1995 Chevy s10 transmission compatible with a 1996 Chevy S10?

Yes they are the same


Will 1996 Chevy s10 transmission fit in a 2002 s10?

Yes


Where is the ecm located in a 1996 Chevy s10 pickup?

Under the hood, on top of the passenger side inner fender.


Where is the electronic flasher located on a 1996 Chevy blazer?

In our 96 Blazer S10, it was behind the radio. We had to remove the radio to get to it.