Remove the tire and wheel from your 1996 Toyota Tercel. Remove the end of the axle. Remove the wheel bearing seal. Remove the wheel bearing nut. Remove the wheel bearing. Reverse the process to install your new wheel bearings.
There is a knob you twist beside your steering wheel close to your drivers side door twist it then the dash lights will brighten up this is what you have to do in my 1996 tercel so i would think it would be almost the same in a 95 tercel good luck lol
you have to unscrew bulb from back of headlight ( twist then pull out), then the bulb is replaced and do the exact opposite to replace. There may be a small clip you can use a flat head screwdriver to help with this. Hope this helps.
It is located inside the inlet pipe where the lower hose meets the engine block. It is held in by three 10mm bolts attached to the engine. The thermostat itself looks like a small rod, with a spring around it, and a curved open cap on top.