It is located inside the V of the engine blocks under the plenums
how do you remove alternator on v6 holden vectra
The thermostat on a Jeep 3.7L v6 is under the housing where the lower radiator hose attaches to the engine.
Follow the upper radiator hose to the engine. The hose is attached to the thermostat housing. Remove the thermostat housing to expose the thermostat.
It is under the thermostat housing located at the engine end of the upper radiator hose.
If you follow the top radiator hose from the radiator , it connects to a housing that is bolted to the front of the engine . The engine cooling thermostat is INSIDE the housing on your 2001 Ford Mustang , 3.8 liter V6 engine
The thermostat is under the housing where the upper radiator hose attaches to the engine.
The thermostat in a 2001 Isuzu Rodeo V6 LS is located on the driver's side of the motor. It is the lowest part that can be seen bolted to the motor on that side. The location is below the EFI, or Electronic Fuel Injector (carburetor).
Follow the upper radiator hose to the engine block. The part the hose is connected to is the thermostat housing. The thermostat is under it.
its in the bottom hose becuse i have an 01 sebring with the same motor as your car its the 6g72 v6 i had to change mine out
195 is the thermostat that goes in a V6.
remove all the coolant in the system take out thermostat put new thermostat in fill system...
the guys on www.vvoc.com will help you out with any vectra questions you have mate