Follow the lower hose to the engine. The thermostat is in the water outlet behind the bracket the AC belt tensioner is mounted. Removing this bracket and the fan shroud makes this an easy job.
It is not hard if you have the proper tools. Drain the radiator and remove the upper hose at the engine. Remove the thermostat housing and install the thermostat. Clean the surfaces and install the new thermostat.
Its very easy. two bolts but you will need to remove the batt and just follow the large hose from the radiator to the engine and that casing will be the thermostat
Yes they do have struts and they aren't hard to change
if its an automatic change fluid filter in transmission!!
follow top radiator hose to the end, there is the thermostat in housing on end of hose. on 3.1 v6 it is under exhaust manifold! it looks like it would be hard to change but it can be done.
is in hard to replace a thermostat on a 2001 bmw 325i
No there is not. I replaced mine on a 1999 and it wasn't to hard
Where is thermostat on 97 Oldsmobile cutlass supreme 3.1 Liter. How hard is it remove.
it is 100% impossible no matter how hard you try like do u know every single number before infinity do you know how to write infinity if the answer to those questions is no then no
Answerthe thermostat is located on the drivers side of the motor underneath a large wiring harness and is difficult to see. try following the top radiator hose backwards. ....not too hard to change either. DEPENDS. If it is the 24 valve OHC engine, the thermostat is on the passenger side, front, bottom of the engine. It's a little hard to get to but just two bolts.
Just take it out and put the new one in. They are hard to pull out.
1998 Isuzu Amigo did not have the options to have a hard top. 1999-2003 had hardtops. yes you can uses a 99-03 hard top on a 1999 (I did) have to change some wiring and some bolts.