It does not have a thermostat sensor. There is no need for one....
It is on the intake manifold near the thermostat housing.
The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.
knock sensors on a 2005 silverado are located under the intake manifold
beside the thermostat housing on top of the engine
It is screewed into the intake manifold right beside the thermostat housing.
Screew it out, and screew the new 1 in.
The process to change the pressure sensor is the same for any engine in the 2005 Silverado, but the location may change between engine types. The sensor should be close to the oil filter. Remove the sensor wire, then screw the sensor out. Screw a new sensor in, then reconnect the wire.
It is behind the starter. You will have to remove the starter to even see it.
Need engine size.
The outside temperature sensor on the 2005 Chevrolet Silverado pickup is located in the top of the dash next to the windshield. Look for an area that looks like a speaker but is shaped like a triangle.
There are 2 knock sensor under the intake manifold, You will need to remove the intake to get to them.
The IAT ( idle air temperature ) sensor is built in to the MAF ( mass air flow ) sensor.