it's on the side of the throttle body(3 prong plug)
The throttle position sensor is on the throttle body at the end of the throttle shaft.
the throttle position is under the hood, around the engine, and under the tap. .... you know... the thing that hold the oil in.
this should help you out! Brian
Yes. The THM125C has a governor. The governor is just below the speedometer sensor. 1986 Pontiac fiero service manual section 125C page 22.
on throttle boyy in corner
V6 crank position sensorThe crank position sensor is part of the distributor on a V6 All Fieros equipped with a distributor (1984 - 1986 4-cyl and 1985 to 1988 V6) have the crank sensor inside the distributor. It may also be known as a distributor pickup or HEI pickup.Fieros with DIS (1987 to 1988 4 cylinder) have a crank sensor on the back side (engine side) of the ignition module extending into the engine block. The ignition module is the flat base that the ignition coils are attached to.
5,672 Ohms at half-way open...good luck!
well, when you look on the throttle, there may be a screw that you can loosen or tighten to adjust it, if not im not sure of another way, however, i believe it has a throttle position sensor, so if you tamper with it, the computer can take over, and even it out, but im not positive. hope this helped
A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer
A low oil pressure reading when idling for a 1986 Fiero is normal. As long as the oil pressure goes back to normal when the car is being driven, there should be no problem. If it is not, then the oil pressure sensor or the oil sending unit should be looked at.
Yes
how do you replace side windows 85 fiero