Want this question answered?
The belt itself is rubber and wouldn't have a mark. The mark is usually at the top of the engine and one on the upper belt gear that when they are facing one another means your on the money.
pin the engine on the flywheel. line the timing mark on the cam gear with the timing mark located on the timing cover. the mark on the cover is located at the top and is just a bump formed in the cover.
diagram of timing marks 2c engine toyota
When timing the timing belt you use the mark for top dead center on the crank. To do that you will have to do a few different steps.
The fuel pam timing mark Scania 400 is on the engine.
There are three marks to line up... before you remove the lower timing belt cover there are the marks on the little gauge that is integrated into the cover that line up with a mark on the main crankshaft pulley (to actually time it while the engine is running) there are also marks on the camshaft sprocket (big sprocket at the top of the engine seen with the upper timing cover removed), that lines up with a white mark on the upper rear plastic timing cover. And finally if you replace the timing belt there is a mark on the crankshaft sprocket that lines up with a mark cast in the face of the aluminum engine block. mnemonic76 1988 Pickup owner
A timing mark is usually a white line on the timing belt to sync the firing of cylinders in an engine. You can see this line when the engine is turned off or with a timing light also a strobe light when the engine is running.
make sure the camshaft sprocket timing mark is aligned with the upper back cover and cranksaft sprocket timing marks align the crank mark with the cast-in mark on the front seal retainer.
the timing mark (z) of injection pump and the mark (z) to cam shaft the other markof cam shaf (y) to the idler geer (y) and the (x) mark of idler to main shaft (x) mark
The timing mark on a Chevy Inline 6 engine is located on the flywheel. It is a steel ball. The timing needs to?æbe located at 4 degrees BTDC.
2.4l dohc balance shaft timing mark, crankshaft sprocket timing mark,oil pump timing mark and camshaft TWO timing marks 2.4l sohc balance shft timing mark, crankshaft timing mark, oil pump timing mark and ONE camshaft timing mark. it is complicated only that everymark must be bang on, if not the pistons will hit the valves and YOU get to rebuild engine.
timing on an 03 suzuki xl7