The automatic transmission ( transaxle ) fluid dipstick is near the firewall
where the transmission is bolted to the rear of the engine
Right where the transmission dipstick goes. You will need a funnel
On a 2000 Mercury Sable : The automatic transaxle ( transmission ) fluid level dipstick would be near the firewall just to the drivers side of the engine ( where the transaxle is bolted to the engine )
On a 2000 Mercury Cougar : No , only the automatic transaxle ( transmission ) has a dipstick
According to the 2000 Mercury Sable Owner Guide : ( Motorcraft MERCON - V , automatic transmission fluid in both types of automatic transaxle / transmission )
The Mercury Sable transmission has a fluid capacity of 12 quarts. You can use any SAE certified automatic transmission fluid.
According to the 2000 Mercury Sable Owner Guide : Motorcraft MERCON automatic transmission fluid is used as the power steering fluid
mercury sable
A 2000 Mercury Sable might have a vibration at low speeds after changing the transmission fluid because of a lack of fluid or leaking fluid. Check the transmission case for leakage and check the fluid level before driving again.
A transfer case is used if a vehicle is all wheel drive or 4 wheel drive capable and is located at the back of the transmission . In a 2000 Mercury Sable the " transaxle " is bolted to the back of the engine towards the drivers side
It's called a "maintenance free" transmission. No dipstick.
The 2000 Mazda 626 transmission dipstick is located in the engine compartment, near the firewall. The transmission dipstick will have a bright yellow handle.
The 2000 Mercury Sable starter can be found on the right hand side of the engine. The starter will be near the back of the engine.