0
Where is the turn signal relay on a 1986 Volvo 740 and how do you replace it?
Wiki User
∙ 14y ago
It's behind the ashtray, it's a black relay and the easiest way to change it is to lift out the fuse box.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is starter relay located on 1986 Volvo 240gl?
Where is starter relay on a 1986 volvo 240gl
How do you remove right turn signal relay on 1986 merqury grand marquis?
how to remove right turn signal relay on 1986 mercury grand marquis
Replacing Turn signal relay for a 1986 Volvo 240?
SIGNAL RELAY IS A BOX BEHIND THE LH CONSOLE PLASTIC NEAR THE GAS PEDAL ! Remove panel 1 Phillips and 1 odd fastener plastic ! Look behind the carpet near the front away from the pedal !! KM
Where is the starter relay located on a 1986 Volvo 240dl?
I believe there isn't one.
Where is the headlight relay on a 1986 Volvo 740 gle?
in the center console, under the Radio
Where is the turn signal relay on a 1986 Honda prelude?
The turn signal/hazard light relay is directly behind the fuse box. its about an 1 1/2" wide and about 2" long and its black.
How do you make blinkers blink on a 1986 Chevy truck?
The signal flasher relay may be at fault, swap it with the emergency flasher relay to see.
Where is the tail light relay for a 1986 toyota truck located?
left kick panel by clutch right behind the turn signal relay
Where is the Location of turn signal relay for 1986 harley Davidson 883 sportster?
try the headlight housing
How do you replace a 4 way flasher on a 1986 Chevy Astro Van?
It is quite simple to replace the four-way flasher relay switch in your 1986 Chevrolet Astro Van. The four-way flasher relay switch simply plugs in and out.
1986 240 DL Volvo automatic transmission won't go into overdrive?
Check either: Solenoid, Wiring, Switch, or OD Relay.
Why would a 1986 Corvette over heat after changing the fan and heat switch but wont click on?
Yep. Had the same problem on my 86. Changed the fan,sensor and relay.If you jumper the outer terminals on the relay connection you can tell if the fan works. If it does fine but the signal to 'throw' the relay from the ecm isn't working.Check with a test light for this signal.If ok replace relay.
