A 1996 Ford Explorer should be OBD II / EEC V with a data link connector in the
lower part of the dash , below the steering wheel , between the inside hood
release and the parking brake release and behind a small removable plastic panel
( if there was an " EEC TEST " connection it would be beside the Power Distribution
Box on the drivers side of the engine compartment )
Yes
Under the ash tray.
driver side under the dash. kind of where the hood release is located. driver side under the dash. kind of where the hood release is located.
Lamp Out Warning Module. Located under the center console. Jethro W
Where is the tensioner located on a 1996 Ford Explorer V6 XLT?
behind the rear passenger seat under the panel of what would be the trunk
According to my Haynes repair manual it is under the dash to the right of the steering column.
On a 1996 Ford Explorer : The power distribution box is located in the engine compartment , on the drivers side
behind the driver side kickpanel.
Underneath the Explorer , below the drivers door , mounted in the frame rail
The fuel pump inertia ( shut off ) switch is located in the right front passenger footwell , by the kick panel on your 1996 Ford Explorer
where is fuel filter on ford explorer 1996 Under the bottom, driver's side about mid-way back. You'll need the special fuel line spring compressor tool, available at Advance Autoparts/Autozone.