Want this question answered?
Closest to serpentine belt.
There are 3 generations where the Toyota MR2 was produced. The 1st time was 1984-1989. The 2nd time was 1989-1999. The 3rd time was 1999-2007.
Which engine?? 5SFE or the Turboed 3S-GTE?
The 2.2L early 90s enging was DOHC, not SOHC and no, it would not be easy to put that engine and transmission into a MkI MR2.
Its the mk2 late 1989-1999 Kind regards www.mr2-Ben.co.uk Toyota mr2 mk2 New & Used Spares
Toyota first showed its concept car which would become the MR2 in October of 1983. The MR2 was officially released in 1984. A second generation of MR2's were released in 1989 (1990 in North America) and a third was released in 1999.
Take the trans out, the clutch is inside the trans ^_^
In the trunk, behind the engine, behind the panel on the driver side
The better question would be how much does it cost to PASS...
If the Camry is anything like the MR2, the procedure requires a brass chisel, if I remember correctly. I do remember that you DO NOT pull on the half shaft as this will cause the interior u-joint thing to separate and spill white lithium grease everywhere... I STRONGLY suggest acquiring a factory service manual or seeking the assistance of someone that has completed this task before attempting to remove the drive shaft. I learned the hard way on the MR2... .
Find all your MR2 MK1 answers on the best MR2 forum. Go to : www.mr2oc.com MR2 owners club. See you there!!
It depends on a combination of rim and tire size. I would not go above a 17" myself.