answersLogoWhite

0


Best Answer

On a 1990 Plymouth Voyager 3.0, the water pump is located behind the timing cover. The timing belt is what drives the water pump.

User Avatar

Wiki User

โˆ™ 2014-10-07 02:00:40
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the water pump located on the 1990 Plymouth Voyager 3.0?
Write your answer...
Submit
Related questions

Where is the fuel pump located on a 1990 Plymouth voyager?

It is in the fuel tank.


Is there a car named the voyager?

Plymouth made a Voyager minivan from 1990 to 2000.


Where is voltage regulator located on 1990 Plymouth voyager 3.3?

The engine computer handles the voltage regulation duties.


Is the 90 Plymouth Voyager front wheel drive or rear wheel drive?

A 1990 Plymouth Voyager is a ( front wheel drive vehicle )


1990 Plymouth voyager return water line?

Only if you drive the vehicle. It can't return the water line without the receipt. Get literate!


How do you replace an egr valve on a 1990 Plymouth Voyager 30?

take it in


Where is the Engine Management System on a 1990 Plymouth Grand Voyager 3.3L V6?

It is located on the drivers side front fender next to the battery


Where is the fuel filter located on a 1990 Plymouth Voyager?

The Fuel Filter on the Voyager is under the Vehicle. Get it up on a ramp, and you will find it under the driver or passenger side along the the door track. Good luck


1990 Grand Plymouth Voyager cuts out and dies for no reason then starts after a couple of times cranking it?

If your 1990 Grand Plymouth Voyager cuts out and dies for not reason, but starts after a couple times of cranking, the starter might be going out. You can have the starter tested.


Where is the water pump located on a 1990 Plymouth Acclaim?

It is under the timing cover on a 3.0L


Where do you find 1990 Plymouth grand voyager fan relay?

It will be in the fuse block under the hood.


Where is the thermostat on a 1990 Plymouth Voyager?

Under the housing at the engine end of the upper radiator hose.


What is the tire size for 1990 Plymouth Voyager?

The tire size for a 1990 Plymouth Voyager van is P195/75R-14. At least that is what mine came with. I currently have P205/70R-14 installed. Check the tag on the Drivers door for the original size installed on yours.


How reset maintance required dash lite 1990 Plymouth voyager van?

A scan tool is required.


Which Plymouth voyager engine has a timing chain 1990?

The 3.3L has a chain. The 3.0L and 2.5L have timing belts.


How do you set the clock in a 1990 Plymouth Voyager?

This information can be found in the owner's manual. This information can be found in the owner's manual.


Where is the drb 2 port on your 1990 Plymouth grand voyager?

Under the hood, along the driver side inner fender panel.


How do you change the ball joints in a 1990 Plymouth voyager?

I believ that a special tool is required it might be cheaper to have it done than to buy the tool


How do you retrieve computer codes from a 1990 Plymouth Grand Voyager?

turn the key on and off 3 times and count the check engine flashes


Where is the fuel filter located on a 1990 Plymouth Voyager LE?

the fuel filter is located directly above the fuel tank. tank must be dropped in order to reach the quick connect fitting. this is a different person..... On my 90 Voyager my in line fuel filter is under the van, crawl up under the passenger side door, you should then see it in that area. ~Christina~


Plymouth Voyager transmission will not shift into third?

On my 1990 Voyager, the transmission has a "safe," or "limp" mode. If something is wrong with the trans, it will not shift out of second gear. This is supposedly to allow you to drive to the repair shop at a reduced speed.


Where egr valve on 1990 Plymouth laser?

The 1990 Plymouth EGR valve is located on the outside of the air cleaner housing. The EGR valve can be found on the back side of the housing.


Where are the input and ouput transmission sensors for a 1990 Plymouth Voyager?

They are the two wire sensors that are screwed into the front of the transmission case. The input is closer to the engine.


How much would a drive shaft replacement cost on a 1990 Plymouth grand voyager?

Replacing one side halfshaft could range between $300 to $400.


Where is the input speed sensor on a 1990 Plymouth Grand Voyager?

The input speed sensor is the two wire sensor on the front of the transmission case closest to the engine.