Windshields and Wipers
Jeep Liberty
Jeep Liberty Sport

Where is the windshield washer pump in a 2002 Jeep Liberty?


Top Answer
User Avatar
Wiki User
2015-07-14 15:04:51
2015-07-14 15:04:51
Windshield washer pumpJust so happens I did this job this past weekend. The windshield washer pump is located behind the right front tire. Remove the right front tire. There is a small cut-out in the plastic wheel well to access the turn signal light. Open this cover and you can see the washer pump. Pull the hoses off each side of the pump, remove the wiring harness (on top of pump). The pump sticks into the washer reservoir at the lower end with a rubber grommet. The pump also has a round stem that snaps into a lug on the reservoir. All you have to do is pull and wiggle, pull and wiggle, and pull and wiggle the pump to remove it. After removal, you will see the round stem on the pump and the lug on the reservoir - just be sure to snap it back in when replacing the pump. Be careful not to "roll" the rubber grommet when installing the pump into the reservoir.

Related Questions

User Avatar

Your windshield washer fluid reservoir is low.

User Avatar

The windshield washer fluid level is low.The windshield washer fluid level is low.

User Avatar

The 2002 Jeep Liberty takes 19" replacement windshield wiper blades on both sides front.

User Avatar

Your windshield washer fluid is low.

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.