It is attached directly to the wiper motor.
it is located on the front of the wiper motor.
Mounts on top of the wiper motor
In the compartment where the jack is. It is in a black box by the pillar. Open lid and remove circuit board and replace it.
why is my dash board lights not working
Under the dash board on the passengers side.
chances its not the motor but the wiper module board located on the wiper motor. just remove the wiper motor and the module board is connected to it.
There are several circuit boards in that vehicle. Need to know which one you are looking for.
underneath the drivers seat, on the floor board
The electronic control module is located behind the right side of the dash board
attached to the windshield wiper motor. Its the plastic box with 4 torx screws. The wiring harness plugs into the pulse module
The 4x4 control module is located behind the kick panel in the passenger side floor board. The module simply unplugs and you plug the new one in.
The Ford Explorer was produced from the years 1990 to present. The wiper motor pulse board module in a 1998 Ford Explorer 4.0 L is located on the firewall, behind the engine in the middle.