answersLogoWhite

0

  • Chevy Silverado
  • Chevy Suburban
  • Ford Explorer XLT

Where is the Door Lock Module located on a 99 Suburban K1500 and how do you replace it?

User Avatar

Wiki User

βˆ™ 2007-05-19 23:00:37

Best Answer
Copy

In the compartment where the jack is. It is in a black box by the pillar. Open lid and remove circuit board and replace it.

2007-05-19 23:00:37
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

How do you replace a fuel pump in a 1996 k1500 suburban?

You must remove the fuel tank as it is located on top and inside the tank, unless you can remove it without dropping the tank.


1994 Chevy k1500 no spark no fuel?

Need to check or replace the ingnition module in the Distributor.


Where is the oxygen sensor located on a 1993 Chevy Suburban k1500?

Either before or after y pipe, or both, depends.


What is the oil capacity on a -95 K1500 Suburban?

The gross weight rating capacity on your 1995 K1500 suburban is stated at 3000 pounds. The towing capacity of your 1995 K1500 is stated at 7500 pounds.


Where is the engine control module located on a 1995 5.7L Chevy K1500?

it is bolted to the distributor just under the distributor cap.


What transfer case is in your 1998 k1500 SUBURBAN 4x4?

NP246


Can you put a 454 in a 96 k1500 suburban?

yes, yes you can


Why does blower motor switch keep burning up on 99 k1500 suburban?

The blower motor is drawing to many amps, replace the blower motor.


How much does a Chevy Suburban 1500 weigh?

my 1995 k1500 suburban weighs in at 6,000 lbs. full of fuel


What is the fuel tank capacity of Chevrolet 1998 k1500 suburban?

The 1998 K2500 Suburban has a 44 gallon gas tank.


How do you replace light bulbs for radio on a 1999 Chevy Suburban?

http://www.corvetteradios.com/ sells the bulbs for the GM k1500 radios. They have a diagram showing how to solder them to the circuit board on their site.


Will a 99 K1500 suburban transfer case fit a 06 K2500 suburban?

NO not even close. You must stay under the year of 1999


Where is the blower resistor on a 1999 K1500 Suburban?

Attached to the blower motor under the passenger dash


What engine is in a 1997 k1500 4x4 Chevy suburban with a 5.7 liter engine?

That is a 350 engine.


Where is the anti-lock brake control module on a 1994 Chevy k1500?

in the engine


96 Chevy k1500 350 vortec wont fire and no fault codes?

I would replace the ignition module in the distributor. Also need to make sure the coil and wire is good too.


What size socket fits the lug nut on a 2004 Suburban K1500 with 17 rims?

22 mm


What transmission is in my 1998 k1500 SUBURBAN 4x4?

4L60 is the most common automatic transmission in GMC trucks


What is the difference between a K1500 and a C1500 suburban?

K is for 4 wheel drive C is for 2 wheel drive


Where can you get a diagram of the vacuum lines on a 96 Chevy Suburban K1500 2WD if the dealership will not give it?

It is important to have a diagram of all the line in a car while owning it. A person can get a diagram of the vacuum lines in a 1996 Chevy Suburban K1500 2WD by purchasing the maintenance or repair manual at an auto part shop.


Where is the fuel pump relay located on a 1999 GMC Suburban K1500 4x4?

the fuel pump is located in the fuel tank, but the fuel pump relay is under the hood with the fuses. Drivers side near the firewall. It is under a black plastic cover.


Brand new battery in 1994 Chevy K1500 turns over wont start?

Have you checked the ignition control module? Have you checked the ignition control module?


How would you remove and replace a rear passenger door on a 1997 Chevy Suburban K1500?

the door hinges are welded so you have to use a small hammer and small punch to tap out the pins that look like big nails.


How do you replace the slave cylinder in 96 Chevy C1500?

How do you replace a slave cylinder in a 96 chevey k1500


What is the magic button to set the clock on a 1999 K1500 SLE Suburban?

Not to be smart but there is a little button on the face that says "clock".