answersLogoWhite

0


Best Answer

its located in the fuel tank,there is an inspection cover under the rear seat under a black plastic cover

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where on a Vauxhall Corsa 1996 is the fuel pump And is it electrically powered?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuse for cigerette lighter on a vauxhall corsa 1996?

The fuse for the cigarette lighter on a 1996 Vauxhall Corsa is located in the fuse box under the dash. It is found in slot 23.


What engine oil for 1996 1.2 vauxhall corsa?

engine oil 5W-30


What are the torque settingsfor a Vauxhall corsa 1.4 8v 1996?

110 nm dude


Does the1999 corsa envoy 1.0 have an immobilizer?

All Vauxhall cars have (in the UK) had an immobilizer fitted since 1996.


Where can i find a Vauxhall Corsa 1996 Stereo Wiring Diagram?

go to Vauhall page on internet, see list of manuals,and look up one for corsa ,you should be able to find what you are looking for


What does it mean on a 1996 vauxhall corsa when the handbrake warning light is always on?

this also illuminates when brake fluid is low either your brake pads are worn out or you have a leak


When did Spriggan Powered happen?

Spriggan Powered happened in 1996.


Does a 1996 Mercury Marquis come electrically wired for a hitch?

No


Where is the speed sensor on a 1996 corsa?

Look on the transmission by where the axles come out


What grease is used in the gear selector switch of a 1996 vauxhall corsa automatic?

Dielectric grease (a.k.a. non-conductive grease) and Maplins grease would do the job. If you have the flashing S problem on cold weather, don't use the regular petroleum-based grease.


When was Spriggan Powered created?

Spriggan Powered was created on 1996-07-26.


How do you bypass or disable the immobilizer on vauxhall corsa b?

Hi, if it is a keypad one, lift the keypad from the centre console, put in the correct code and start the car, when the car is running remove the plug from the back of the keypad. You will then be able to start without inputing any code.Best wishes, Jim.