depends on the year model I know that my 2001 has 2 and they are located under the intake manifold.
what part of motor is the knock sensor located on 1996 Chevy S-10 4 cyl. passenger side of engine block
Knock sensor is located in block below rt.[ pasasenger] side motor mount.
If a knock sensor was bad, the check engine light would be illuminated and the code(s) set would indicate so.
behind back of engine on top.
Knock sensor = CKP sensor on this vehicle.
usually on the side of the engine by the crankshaft. The knock sensor provides the computer the position of the crank shaft to give it the right information to get correct timing. A bad knock sensor will cause it to run ruff or not at all The knock sensor senses spark knock or pinging and sends that info to the ecm. The ecm then in turn retards the timing until the ping stops. You can test the knock sensor with the engine running, with a timing light attached watch the timing marks as you tap the engine block with a small hammer, you will see the timing retard briefly.
knock sensor
YES IT DOES. Yes it does.
the knock sensor is located toward the front of the engine block and it"s only used on ohc v6 engines. good luck!
under the distributor cap
Remove the intercooler first. The knock sensor is located under its loation. But you will have to remove some breather pipes to get to it. You will need a long ratchet.
intakeplimum