answersLogoWhite

0

Remove the intercooler first. The knock sensor is located under its loation. But you will have to remove some breather pipes to get to it. You will need a long ratchet.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Can you fit a genuine set of Subaru impreza turbo 17 inch alloys from a 2001 impreza onto an R reg 1997 Impreza turbo?

Yea mate no problem


Where is the knock sensor on vectra x reg 2.0 sri?

The knock sensor on a Vauxhall Vectra X Reg 2.0 SRI is typically located on the engine block, specifically on the lower part of the engine near the cylinder head. It is usually mounted on the side of the engine, often near the exhaust manifold. To access it, you may need to remove some components for better visibility and reach. Always consult the vehicle's service manual for precise location details and any specific procedures.


Where is throttle position sensor on your 51 reg 2 2 dti?

I don't happen to know what a "51 reg 2 2 dti" is, however the throttle position sensor is found on the end of the throttle shaft.


Where is the temperature sensor for the engine fan located on a peugeot 406 v reg?

The water temperature sensor is located on the front of the engine. You will find the sensor behind the thermostat housing.


Where is the mass air flow sensor or meter on your 1997 P reg vauxhall corsa?

just after your Airfilter


Where is the fuel temp sensor on a 1987 Nissan 300zx none turbo?

no the 85 it is on the fuel pressure reg it should be the same


Temp gauge not working fiesta 1.3 s reg you know what may be wrong?

Could be temperature sensor Could be gauge


Ford Mondeo p reg radiator fan not working fuse ok?

that would be either fan switch or temperature sensor


My Cooling light on dash board is staying on vauxhall astra s reg is this norm?

no will probably se the sensor on the bottom of the header tank


How tall is Reg Reg Askew?

Reg Reg Askew is 5' 11".


Where is the hall sensor on megane scenic 1.6v rt 1998 p reg situated and how would you go about cleaning it Have problem starting my car and have heard that cleaning or replacing hall sensor may help?

It doesn't have a hall chip or a hall effect sensor, it has an inductive pulse cam/crank sensor. You can clean those.


You have changed the coil on your citroen saxo 1.1 t reg and there is still no spark at the plug?

the usual fault is a dirty or open circuit crankshaft sensor