answersLogoWhite

0


Best Answer

It will be most efficient if placed at or near the bottom so that convection will move the heated water upwards, warming the water above it as it rises and allowing the colder water to sink downwards towards the coils. If the heating element were placed higher up, the water below would have to warm almost exclusively by conduction which would take much longer.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where should a heater in a water tank be placed to efficiently warm the water?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can a hot water heater be placed outside in Miami?

Yes, a hotwater heater may be placed outside anywhere in the state of Florida. It should be under cover such as a garage or shed.


Should the top thermostat be set hotter in a hot water tank than the lower one?

No, you will have different temperatures of water inside the water heater, which will make it difficult to get a consistent temperature out of a shower valve or faucet. The heater will also not work correctly or efficiently.


How can you wire both water heater elements to work at the same time?

Yes it can be done but should be carried out by a qualified electrician


Why heaters are not placed at the bottom?

Inevitably, there will be some dust and much in the water supply, and the heater should be above this level to ensure it will not overheat.


Why should the immersion heater be placed at the bottom of the storage tank?

It gets warm but only if the immersion heater is switched on. The warmer water will rise slowly and start circulating in the tank, so you end up with a tank full of hot water.


Can a tankless water heater be placed on easement?

Only if allowed by the terms of the easement.


Should you have one or two heaters in your 4ft tank?

Visually it is more appealing to have only one heater. A four foot tank isn't too terribly large, so as long as the heater is placed in an area where the water flows around it, then one heater should be sufficient. Ideally, you could use an in-line heater, if you have a canister filter.


Where should a service valve be located to isolate the hot water supply from the hot water storage vessel to the taps is it the primary return or primary flow or cold feed or open vent?

The isolation valve should (must) be placed on the cold water side (and/or the return side), entering the water heater. Placing the isolation valve on the hot or outlet side of the water heater has the potential of creating a bomb.


What is an example of converting electrical energy to thermal energy?

Example is ,an electrical heater connected to a main switch and the heater is placed in a bucket filled with water.


Should PVC pipes be placed on the hot water heater connector?

No most certainly not. In most countries this is illegal and you will be prosecuted if found guilty. Always use metallic pipes for hot water, inlet or outlet.


What distance must an air conditioner unit be placed from an outside gas water heater?

5m minimum


How do you turn up water heater?

There should be a dial on the front of the heater that you set the temp. with.