0
What else can I help you with?
Is there a chip in a 1998 gmc jimmy key?
No, there is no transponder in the key on a 1998 GMC of any kind. http://www.brandtlocksmiths.com/doc/DOcGM.htm
How do you reprogram a key fob for a 1994 gmc jimmy?
the bastards at the dealership have to do it...had it done, not cheap.
Why after turning off your 1997 GMC Jimmy you occasionally cannot turn the key enough to remove it?
Spray some powdered graphite into the mechanism and see if that helps. It may just need some lubrication.
Fuel pump pressure for 1996 gmc jimmy?
KEY ON ENGINE OFF.... 60-66 PSI
Where is the the starter switch located on 1995 gmc jimmy?
on the side of the steering column you put your key in it and turn
How do you change the key cylinder in a 1995 GMC Jimmy?
Type your answer here... uninstall 1995 Chevy g m c truck key cylinder
How do you replace a key lock solenoid 1997 jimmy?
To replace the key lock solenoid in a 1997 GMC Jimmy, first disconnect the vehicle's battery to ensure safety. Remove the door panel by taking out screws and clips, then carefully detach it. Locate the solenoid, disconnect the wiring harness, and remove any mounting screws. Install the new solenoid by reversing these steps, ensuring all connections are secure before reattaching the door panel and reconnecting the battery.
Why cant you take your key out of your 1996 gmc Jimmy?
My guesses are that 1. The shifter is not in park. 2. The transmission is not in park. (Other end of shifter cable.) 3. There is a safety deal on your key, grabs ahold if it for things like not being in park. This could have gone bad. -Idea, (On a late 1996 jimmy/1997) On the bottom of your steering column is a half inch round plastic tab you can remove. You can then put a screw driver up in the hole to manually push the 'key locker' open.
How tall is Jimmy Key?
Jimmy Key is 6' 1".
Can you pull a code on a 2001 gmc jimmy without a scanner?
Yes, you can retrieve diagnostic trouble codes from a 2001 GMC Jimmy without a scanner by using the "key-on, key-off" method. Turn the ignition key to the "ON" position three times in quick succession, stopping at "ON" on the third turn. The check engine light will then flash a series of codes, which you can count to identify any issues. However, this method may not provide as detailed information as a scanner would.
Where can I buy a turn key engine for a Gmc sierra 3500 v8 6.5 lt turbo diesel?
Turn key engine for a Gmc sierra 3500 v8 6.5 lt turbo diesel can be bought in Ontario - Kijiji Ontario
The key will not turn on your 1991 GMC Jimmy S10 Thieves broke the steering column and took the car on a joy ride After being repaired now the key goes in and does not turn at all How can you get the?
Is the key correct? Lock smith might be your best course.
