0
What else can I help you with?
Is plastic pipe the best product for new plumbing?
Plastic pipe is both affordable and durable, so using it for new plumbing is a good idea.
How do you fix a plumbing vent pipe?
Plumbing vent pipe is installed through a cathedral ceiling and metal roof surface there is no easy access into the roof cavity. In an attic after cut off the elbow whose female end contained the remains of the ABS pipe, glued on a short extension and new elbow in the attic, and glued a new plumbing vent rooftop riser into the new elbow. For more information visit at: alliedallcityinc.com
Draining Pipe?
form_title= Draining Pipe form_header= Keep your drainage clear with a new pipe. Do you need to remove an existing pipe?*= () Yes () No Where will the pipe be installed?*= _ [50] Do you currently have any other plumbing issues?*= () Yes () No
How does a saddle drain work in plumbing systems?
A saddle drain is a type of fitting that is used to connect a smaller pipe to a larger pipe in a plumbing system. It is typically used to create a branch connection for a new fixture, such as a sink or a toilet. The saddle drain is installed by cutting a hole in the larger pipe, attaching the saddle fitting over the hole, and then connecting the smaller pipe to the fitting. This allows wastewater to flow from the new fixture into the main plumbing system.
PVC pipe fittings are mostly used to repair damage drainage lines that what professional would have to be called in to repair?
PVC pipe fittings are typically used in plumbing. Therefore, if a damaged drainage line needs to be repaired with a new PVC pipe fitting, typically a plumber would be the type of professional required to perform the work.
What are the common uses of a copper tee in plumbing systems?
A copper tee is commonly used in plumbing systems to create a branch connection in a pipe, allowing for the addition of a new pipe or fixture. It is also used to redirect the flow of water in different directions within the system.
How do you find area for pipe fitting?
Your question is vague. - Usually plumbing pipe fitting is between studs in the walls. To fit new pipes, find studs with a 'studfinder' then cut down the centre of studs to remove drywall. Install pipe, then refit with new drywall on the 3/4 " of stud each side.
Repair crack in PVC pipe?
You have to determine how long the crack is and then cut out the bad section allowing for that which you can not see (hairline cracks). You will probably need the correct size pipe and connectors (couplings S x S) and PVC cement and PVC primer, a fine saw for cutting the pipe. Dry fit everything making sure the new section of pipe is of the correct length. There is a small situation in which you need the flexibility in the old plumbing to be able to attach the new section. You just have to think it thru. Ken
Plumbing New Territory TX?
Plumbing New Territory TX
Can a new tankless water heated be attached to old galvanized plumbing?
Yes it can, you may just need a few more fittings to match the galv pipe to the heater inlet.
What should be used to replace original crimp rings On Quest plumbing pipes?
PEX pipe crimp rings will work. Need proper tool to crimp new rings.
Can you provide instructions on how to replace pipes in a plumbing system?
To replace pipes in a plumbing system, first turn off the water supply. Next, drain the pipes by opening faucets. Use a pipe cutter to remove the old pipes. Measure and cut new pipes to fit, ensuring they are the correct length. Clean the pipe ends and fittings, then apply pipe joint compound or plumber's tape. Connect the new pipes to the existing system using fittings and a wrench. Finally, turn the water supply back on and check for leaks.
