0
Where would the information needed to start a computer be stored?
Wiki User
∙ 7y ago
Most of the programs and info the CPU and computer uses to Boot are mostly from the Hard Drive. The Hard Drive is mostly where all of the instructions come from.
Wiki User
∙ 9y ago
Wiki User
∙ 7y agoSome is stored in ROM; most of the information is typically stored on the hard disk, from where it is loaded into RAM.
Add your answer:
Earn +20 pts
Where would the information be stored to start a computer?
Some is stored in ROM; most of the information is typically stored on the hard disk, from where it is loaded into RAM.
Where the information need to start a computer be stored?
Some is stored in ROM; most of the information is typically stored on the hard disk, from where it is loaded into RAM.
What is 'setup' where is it stored or processed?
When you start a computer, you get a prompt that says something like "Hit F2 to enter Setup". In this case, Setup is the information stored in the BIOS, and is located on a chip on the motherboard called the CMOS. This contains all the most basic information needed to start up the computer and tell it where the memory, hard drives, processor, etc are in order to continue starting up.
When you reboot your system the computer follows startup instructions stored in this type of memory?
On start up the computer fetches information from BIOS. BIOS is a ROM. After that the computer loads OS from Hard disk into the RAM.
How did computer repairs start?
As soon as the first electronic computer was built, it needed repair. that was the start of computer repairs.
Where are the software licenses stored on computer?
It is stored in the Registry -- Click START then Click RUN -- Type in REGEDIT and it will take you into the REGESTRY --- Wildbilly Oki
Rom contains all of the instructions needed to start a computer?
no
What happens when you put a magnet on your computer?
Your computer uses magnetism to store information. The binary code used by your computer to transmit information at the most basic level, 1s and 0s, are stored by your computer in the form of magnetic charges. 1s are represented by magnetized bits and 0s are represented by unmagnetized bits. (8 bits make up a byte)Due to this, putting a magnet on your computer may damage information stored in it, as well as possibly corrupting the ROM in your motherboard. ROM is the read only memory that your computer uses to know how to start up.For these reasons and others, I would highly recommend not putting any magnets anywhere near your computer.
My computer won't start its OS. What do I do?
This is not nearly enough information to give you any information at all.
Where is a startup password or power on password stored?
These settings are stored in the computer's BIOS. Sometimes it is also referred to as CMOS.
What are some colours that start with?
All colours start with something! But what is not stated in the question. More information is needed.
How much amphere hour will be needed to start a 9.5 kw motor?
Not enough information the voltage is needed also.
