0
Where would water leak into the oil to turn it white on a 350 Chevy if I already replaced the intake manifold?
Wiki User
∙ 17y ago
The most likely location of a leak between oil and water passages is the head gasket. The next most likely location is the head, if it is cracked. Very rarely, the block will crack, usually as a result of freezing. A compression test on all cylinders might help to narrow down the trouble.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the knock sensor on a 2002 Chevy Avalanche?
They (2ea.)are in the intake. The intake manifold will need to be removed to get to them. The wire harness and intake manifold gasket should both be replaced when reassembling.
What causes the intake manifold to go bad on a 2002 Chevy impala?
Yes they do at the intake manifold gaskets.
Intake manifold Chevy small block?
what about it?
How to replace the Intake manifold gasket on a 1996 Chevy Astro?
Remove the intake manifold retaining bolts from your 1996 Chevy Astro Van. Remove the manifold gasket and clean the surface. Reverse the process to install the new intake manifold gasket.
Is a 1992 Chevy 350 tbi intake manifold the same as a 1995 Chevy 350 manifold?
There is no difference,,,
Can you use a 350 Chevy intake manifold on a 283 Chevy?
yes
Where is the upper manifold gasket located on a 2000 Chevy s10?
Assuming this is a 4.3L engine, the upper intake manifold gasket would be between the upper intake manifold and the lower intake manifold.
How do you replace a head gasket on a 1999 Chevy Malibu?
The head gasket on a 1999 Chevy Malibu is replaced by removing the coolant, intake manifold, and retaining bolts. The cylinder head can then be removed, the gasket replaced, and everything reassembled.
Will a 1985 Chevy 305 intake work on a 1988 Chevy 305 intake?
intake manifold is DIFFERENT for models 1985 and 1988
Can A350 Chevy intake manifold fit on A307 Chevy engine?
Yes.
Where can you find a diagram for installing a intake manifold gasket on 2003 Chevy venture?
is their a web site, that will provide me with the a print out for the intstalling of a intake manifold gasket for a 2003 chevy aenture.
Where are the 2 knock sensors on 2003 Chevy silverado 4.8l?
They are underneith the intake manifold. You can not see are get to them until you REMOVE the INTAKE manifold.
