answersLogoWhite

0


Best Answer

autozone.com has a selection of many wiring diagrams on their web page. once on homepage, click repair info tab on left side. then click the underlined words "repair guides" in the paragraph. then click chassis electrical. then on the tabs on the right side of the page, click wiring diagrams... or maybe this will help http://autozone.com/az/cds/en_us/0900823d/80/0b/a9/c7/0900823d800ba9c7/repairInfoPages.htm good luck

User Avatar

Wiki User

โˆ™ 2007-04-11 19:41:41
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where would you get a diagram for the 4 x 4 system in a 93 v6 ranger?
Write your answer...
Submit
Related questions

Replace timing belt in 1993 Ford Ranger 2.3 liter?

Replace every 60,000 miles. need picture diagram of 2.3 4cyl ford ranger 93 timing belt diagram


Where is your horn relay on your 93 Ford Ranger?

where is the horn relay on a 93 ranger


Where is the fuel pump on a 93 Ford Ranger?

the fuel pump is located inside the gas tank of my 93 ford ranger


What is the firing order 93 3.0 xlt ranger?

What is the fireing order plug 93 ford ranger xlt 3.0


Can you find the prime factorization of 93 with a step diagram?

It would only have one step. The prime factorization of 93 is 3 x 31.


What type of automatic transmission is in a 93 Ford Ranger?

That would be a version of the A4LD automatic transmission


93 ranger layout fuse box?

I found a fuse box diagram for 91-94 Ford rangers on Autozone.com, small print and hard to read though.


Why would you reset a fuel pump switch on a 93 ford ranger?

Because it had tripped for whatever reason.


Will a 93 ford explorers front seats fit into your 93 ford ranger?

Here you will find all the seats that will bolt right into the ranger: www.therangerstation.com/tech_library/seats.html


Honda civic 93 eg8 electrical diagram?

diagram electrical civic dx


Need diagram firing order 93 town car?

Click the link for a diagram.


Can a 93 ranger 6 cylinder and transmission fit in a 92 ranger with a 4 cylinder?

Yes.


Where can I find a Wiring diagram for a 93 Saturn?

You can find a wiring diagram for a 93 Saturn in the vehicle's owner's manual. You can also check with local auto part stores.


Does the 93 Ford Ranger have a distributor cap?

The 3.0 L - V6 engine has a distributor cap on the 1993 Ford Ranger The 4 cylinder and 4.0 L - V6 engines are EDIS ( electronic distributorless ignition system )


What is all needed to swap a 2.3l for a 4.0 in a 93 ford ranger?

you need whole harness and dash and a few dollars to add on topso as to to swap a 2.3l for a 4.0 in a 93 ford ranger.


Wiring diagrams for '93 ford ranger?

You can find a wiring diagram for your truck online. Autozone.com gives you access to free online repair manuals. You just enter your vehicle information and log on and you can use them anytime.


If your ignition system on your 93 ford ranger is going out what should you replace first?

Nothing until it is properly diagnosed. Take it to a local indepenent garage and have them test it.


Where is the EDIS on a 93 Ranger 2.3?

That's the 2 coil packs where one end of the spark plug wires connect ( Electronic Distributorless Ignition System )


What years of Ford Ranger fit a 1993 Ford Ranger?

Exterior panels: 93-97 Bed: 93+ Interior Panels: 95+ www.FordRanger.net


How do you change the clutch slave cylinder in a 93 Ranger?

very carefully


Where is the fuel pump relay on 93 4.0 ford ranger?

check my answer


Where can i find stereo wiring diagram for 93 f250?

U CAN GET A COPY OF THE DIAGRAM YOU ARE LOOKING FOR IN A CHILTON MANUAL OR DEALER.


What is the factory part number for 93 ranger dipstick in a 2 3 4cy?

part number for ford ranger dipstick T379221


What type brake fluid for Ford Ranger 93?

For a 1993 Ford Ranger : ( DOT 3 brake fluid )


Why would the low beams work and the high beams not work on a 93 ford ranger?

On a '93 Ranger there is an independent fuse in the underhood power distribution center just for the highbeams. Check continuity if it is good, you may have 2 other possibilities. Either the highbeam capsule bulbs are burned out or you have a problem with the highbeam multifunction switch. !!