If you are positive that it is asphalt I would not suggest adhering tile directly to the asphalt. If removal of asphalt is not an option I would install a subfloor and use thinset mortar to adhere the tile. Another option (probably the better option) would be to pour a concrete mix over the asphalt. Than use thinset to install the tile. The concrete will incapsolate the asphalt. Asphalt more than likely has oils in it and can be a hazard.
Use asphalt as a noun. I fell on the asphalt and hurt my knee.
The answer is, it depends. Different types of bituminous cement concrete (asphalt hot mix) use different percentages of asphalt cement. In Virginia, base mixes use at least 4.4% asphalt, while surface mixes are up to about 6%. Liquid asphalt is a little heavier than water; it weighs about 9.4#/gallon (depending on the source and grade). Here's the math: Base mix 2000#/ton x 4.4%/9.4#/gal. = 9.36 gal/ton surface mix 2000#/ton x 6%/9.4#/gal. = 12.76 gal/ton hope this answers the question.
salt is what the states use
"These sausages are Premium grade" Premium=Grade A
The use of asphalt cutbacks is not recommended because they are made by mixing asphalt with lighter oils such as kerosene or gasoline. Over time these solvents evaporate from the mixture, contaminating the environment.
it is best to use a fiberglass one for every turf,field, or surface.
use a measuring wheel
asphalt was discovered during the gold rush when the oil started comming uo they needed new ways to use oil and ...............VIOLA! asphalt
Well, the traditional superpave grade is on the order of PG ##-##, this means, for example. A grade of asphalt, say, PG 70-40 is a mix where the 70 stands for the asphalt temp max over the next seven days after layment of 70 degrees and the min experienced temp the grade should encounter is 40 degrees. This means, that this PG 70-40, is where the 70 degrees is the layment temp max and the min temp to ever encounter is 40 degrees. This mix uses high grade crude oil and aggregate. Other grades use typical crude, modifiers and aggregate depending on the roadway. If your question pertains to what aggregate size, type of modifier or crude selection, this is something that you would need to engineer. Far to complicated to detail in this section. Thanks,
to not ruin the asphalt
To install the Asphalt Arc30 year roof depends with the materials that you will use.