Want this question answered?
Best left to a good gunsmith
i have a 514 bolt and it does not have a magazine it is just a one shooter no clip or magazine
http://remingtonsociety.com/rsa/service or e-gunparts.com The may not sell bolts direct due to fitting an liability.
Bolt Action .22 single shot rifle made from 1948-1970.
I would do it using the 29 times table which I learned at school. However, if your school was not as good, you could use the following logic: 29 = 30 - 1 So 514*29 = 514*(30 - 1) = 514*30 - 514*1 = 514*3*10 - 514 = 1542*10 - 514 = 15420 - 514 = 14906. Or, you could simply use a calculator!
Impossible to answer without knowing who made it.
To remove: Open action, press trigger rearward and pull bolt entirely from receiver. To install: Insert bolt in receiver, push bolt over plunger in bottom of receiver, pull trigger and complete forward travel of bolt; then rotate bolt handle downward to lock.
A darn good site. http://www.urban-armory.com/diagrams/rem514.htm
1226
Hey, you can try pulling back on the trigger while removing the bolt to the rear. Do the same to reinstall the bolt back in the barrel assy. I have a 514 and that's how it is done. Hope this helps . . . John <john.gro@gmail.com>
The Sears 583.10 is a High Standard and the only High Standard bolt action shotgun known is the Model 514. The 514 is worth $125 in excellent condition. Dates of production aren't listed but it's less than 50 years old.
The factors of 514 are: 1, 2, 257, and 514.The prime factors of 514 are: 2 and 257.