The "EGI INJ" fuse is the right fuse to pull out. It will stop the injectors from shooting out fuel. After pulling the fuse out, crank engine for 15 seconds, rest, crank for another 15 seconds, rest crank for another 15 seconds, rest, put the fuse back and then crank. engine should basically start. if the engine is still not starting, take out the spark plugs and put oil around the seal,thread area and replace back. Do the same previous procedure mentioned The engine should finallly turn over now and start.
Headlight fuses for this generation Mazda 6 should be located in the engine compartment fuse box. Pull the lid off the fuse box and flip it over. There should be a diagram there etched in the plastic to tell you what each fuse is for.
Pull the fuse or just simply disconnet it.
pull out the ash tray and the plastic frame behind it.
remove the two nuts holding down the battery harness inside the fuse/relay center, then you can pull it out.
In the engine compartment, on the left side, just forward of the left wheel tower, and just aft of the battery is a covered fuse box with all of the large fuses in it. Pull the cover off. The cover has a legend on it that tells you what fuse is which. The first fuse (closest to the center of the car) is the EGI computer. The second one in is the EGI injectors.
Hello: You can first try,,,looking for the fuse box,,,and see if there is a fuse for the ringing bell. Pull the fuse out,,,and the noise will stop.
Well, that light isn't directly controlled by a fuse - it's controlled through the engine ECM. To pull a fuse for the sake of disabling that light, you'd have to pull the ECM relay.. the problem is, you'd disable the ECM, in turn, disabling the car.
First locate the fuse box under the hood, in front of the battery. Then use a pair of needle noise plyiers to pull the ten amp fuse out. Get your new fuse place it in slot and make sure you press it in firmly.
You can either take out a spark plug on each rotor and spin it over or you can pull your fuel injection fuse and spin it over.
the fuse box is located on the drivers side by the emergancy brake.... the small panle closet to it .... take the one screw out of it and pull it will pop right out
Driver side. Above your left leg. Squeeze tabs on the sides. Pull's down toward you.
Disconnect your battery. /// Rather then disconnecting the battery which effects all the components, just pull the fuse (large fuse block in engine compartment) for the particular item you wish to reset,,, example: switch key to on position, pull injector fuse (30 amp), return key to off position and reinstall the fuse, this process resets the check engine lamp in most cases.