Processor
No, an ammeter should never be placed in parallel with a component - it should always be placed in series, so that the current through the component is measured.If you place an ammeter in parallel with a component, you create a short circuit around the component. Depending on the rest of the circuit, you could damage the circuit, damage the ammeter, create a fire, etc. You certainly will affect the current through the component, and that is not what you want to accomplish.
What is the equivalent component to use in place sl100 transistor? ...
The best method of saving and transporting the amputated finger is to wrap it with moistened cloth (Ringer's lactate solution or saline solution) and place it on ice. Generally, the tissues will survive for about six hours without cooling
EVAPORATIONtakes place at the surface of liquid.heating not requiredtakes place at all temperature.results in cooling since heat is absorbed from the surface.BOILINGtakes place throughout the liquid.requires heating.takes place at different temperature.doesnot results in cooling.
form_title= Heating and Cooling Service form_header= Keep your heating and cooling running smoothly. How old is your heating and cooling system?*= _ [50] Have you ever had to have it repaired?*= () Yes () No Do you have central air?*= () Yes () No
first place a potato which is carved slightly inwards in the salt solution. it adsorbs the solution slowly and the level of the solution decreases.now place the pin at the potato
Dissolving takes place to turn a mechanical (heterogeneous) mixture into a solution (homogeneous solution).
Where you place your HDMI component will depend on what type of television you have. The best thing to do is to consult the users guide or manual in order to find out where the component is installed.
It varies from place to place. However it is often referred to as granitic.
First, disconnect the negative battery cable, and the instrument panel. Drain the cooling system before you raise the vehicle and disconnect the heater core. Remember to dispose of the drained fluid and return every component to its right place.
The solution zone is the place where customers can get help in the area that they need.
Since voltage is electrical potential difference, to measure the voltage across a component, you place the voltmeter across, or in parallel with, the component.