Want this question answered?
You can not. Replacement of the oxygen sensor is the only way.
The oxygen sensor is one of many things that could turn the check engine light on.The oxygen sensor is one of many things that could turn the check engine light on.
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
If the vehicle was built with an oxygen sensor, you will need an oxygen sensor.
must be a oxygen sensor
It's integrated into the oxygen sensor. Buy a new oxygen sensor and you get a free oxygen sensor heater.
Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.
Remove the vacuum hose from the oxygen sensor. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
You start by unplugging the electrical connector. You then use a 7/8 inch wrench or oxygen sensor socket to turn counter clockwise until removed. Reverse steps to install.You start by unplugging the electrical connector. You then use a 7/8 inch wrench or oxygen sensor socket to turn counter clockwise until removed. Reverse steps to install.
Buy an oxygen sensor, some antiseize compound, and a sensor wrench. Unplug the wire from the car. Unscrew the old sensor. Put a little antiseize compound only on the sensor threads, Screw it in hand tight plus a half turn more, plug it in and you're done.
To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.
It will after a drive cycle, if that was the original problem.