Volt meter should be in a 5 volt scale.
full
ford makes a tool for setting the throttle pressure cable(kick down cable).You can buy one of these from your local ford dealer for about mmmmmmmm15 to 19 dollars.easy to use
The throttle position sensor is an input to an engine control computer that sets the amount of mixture provided to the engine, in conjunction with the amount of air flowing into the engine - by setting the ifuel njection solenoid pulse length.
unhook your battery. remove sensor. no setting is needed.
for them
The proper setting is based on the air available. This is to say your location above sea level. The closer you are to sea level the more fuel an engine can burn. The further you are from sea level the thinner the air or less oxygen available the less fuel you are able to burn. When you set the screw you can get an idea of the correct setting by how quick the throttle response. When you have gone to far which is giving the engine to much fuel mixture the throttle response will slow. Start with it turned almost all the way in and turn out 1/4 turn until the throttle response slows then turn back in 1/2 turn.
I am assuming you are asking for the correct machine setting. It depends on the electrode type and size not the thickness of the metal. Each electrode has a correct amperage setting for the diameter of the electrode used and can vary for the position it is used on. Usually flat, horiz., and overhead will be the same. Vertical a little less. Also the thicker the coating the more amperage needed.
The governor spring adjustments
The bones will heal in the wrong position therefore the elbow might not be able to bend and move. If this happens, the way some doctors reset the arm is by re-breaking the elbow then setting the arm in the correct position in surgery.
well i really have no idea
The setting would be around 7 route in order to have a correct setting of axle.
WHAT SETTING ARE YOU REFERING TO ?