answersLogoWhite

0


Best Answer

model rs82p/rs79p

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Which model bulldog remote starter has a remote switch with only 2 buttons on it start and stop?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

In your 2006 grand caravan doors open with console buttons and remote buttons but the ones located by the door will not work?

The overhead switch is probably turned off.


Installed bulldog remote start Why won't 99 suburban start?

First and most obvious, are all of the connections made correctly? The one thing that will mess up a remote starter is a bad neutral safety switch, it will always check to be sure that is set to park or neutral before allowing the start sequence, so check your neutral/park switch and be sure it is functional and connected.


Connecting a Remote Starter Switch on a 1998 Dodge Ram 1500 5.2L Engine?

ok


How do you hook up a remote starter switch?

If you can get to the starter, you hook up one side of the switch to the terminal that goes to the battery and the other side of the switch to the small terminal marked with and "S". "S" is for starter. The other small terminal you leave alone. Applying power to this terminal will damage the starter.


Why will my car start with remote starter but not with key?

There is an electrical problem between the starter switch and the starter solenoid. The most likely cause is a loose connection at the solenoid or the fusable link has melted.


What tool is used to energize the starter motor with the ignition system disabled?

A remote starter switch that most mechanics have in their tool box or a simple jumper wire will work.


Why wont a 91 Chevy baretta not shut off when key is turned off?

Does it have a remote starter? Defective ignition switch?


Your 91' f-150 50 auto is almost dead how do you bypass the ignition switch from the wiring plug using toggle switches and buttons?

I haven't been able to do everything like that, but to bypass the starter switch, run a wire from the accessory fuse to a toggle switch, and then connect the switch to the 3rd bolt on the starter solenoid.


Starter makes grinding noise after engine is warm but if the remote start is used there is no noise is this due to a relay through the ignition switch?

The starter should only be making noise if you attempt to start the car and the starter is going bad. It is possible that the remote starter is bypassing the mechanical starter. Starters are very easy to replace. Be sure to disconnect the car battery before doing so.


How do you trouble shoot a starter problem?

When you try to start engine is there any noise,such as clicking from area of starter?If you can hear a clicking , this usually indicates poor connections.To trouble shoot starter problem, the first thing i would do is determine if it is starter or solenoid.To do this ,you need a remote starter switch,connected to starter solenoid.Solenoid is located either on the starter,or on firewall in engine bay,depending on what vehicle you have. if you dont have a remote switch, you can short the solenoid terminals with a screw driver.When shorting, if the solenoid is good you will hear clicking.If you dont hear anything , replace the solenoid.If you hear clicking and starter doesnt work, pull the starter out and replace .


How do l put a starter bypass switch in a 1975 Chevrolet pickup?

You can jump start an older vehicle like this by shorting out the starter and solenoid with a screwdriver being careful to use one that doesn't ground you. You must have the vehicle switch to on. If you cannot get the vehicle to switch on you can hotwire the wire to the distributor to the battery. Not the safest way but in an emergency. A better way is to get a remote starter switch and wire it to the starter per its instructions. This is not to be confused with one of the newer remote starters which must be patched into the vehicles ignition and fuse box. You can also wire an ignition switch, preferably with an inline fuse, to the starter as well. This is a DIYer so if you have no electrical/mechanical training or experience then I'd get someone to help you. Good luck.


What things should be considered in order to get the best remote car starter?

There are a few things one should consider when choosing a remote car starter. For safety reasons, consider a car starter with a cutoff switch under the hood. For convenience, take in to consideration the transmitting range of the unit, as well as if the unit is capable of keyless entry.