switches and your mama.!! lol haha
Network+ Guide to Networks answer: Bridge, Switch, Router
Zero. No collisions can occur within a full-duplex environment, as transmit and receive operations are performed on another set of wires. Thus, no collision domains would exist. Carrier Sense Multiple Access with Collision Detection (CSMA/DC) is not part of a full-duplex network for this reason.
Switches increase the number of collision domains in the network.
When using network switches, each port on the switch is its own collision domain.
The acronym CSMA CD stands for Carrier Sense Multiple Access with Collision Detection. CSMA CD is a set of rules determining how network devices respond when two devices attempt to use a data channel simultaneously.
For any amount of clients connected to a hub you will get a total of 1 collision domain. A hub is a device that simply repeats all of the signals from the ports and does not separate clients into separate collision domains.
Vampire Tap Big collision and broadcast domains, bandwidth problems.
Packet in Computer Networkingis a slice of DATA that needs to be sent through physical medium of communication to other device on the network. Packet has a well defined strucuture based on Protocol used for identifying source and destination devices. Physical medium can be wired or wireless, depends on the type of Network Interface Card been used. Packets are transmitted over physical medium.During the transmission of Packets from Network Interface Card when two cards in a starts sending signals over the physical mediumat the same time, transmitted signals collide with each other, this is called PACKET COLLISION.This channel of physical medium where packets can collide is called Collision domain. Collision domains are generally created in Networks using HUB devices in their Network Topology. Switch devices in Network confine Collision domain to a single port and enable high speed & collision free communication in a Network.
This is the definition of a computer network. Devices such as routers and bridges create logical network subnets and network domains that computers, printers, and other devices can connect with to join the network.
CSMA/CD (carrier sense multiple access/collision detection) CD (collision detection) defines what happens when two devices sense a clear channel, then attempt to transmit at the same time. A collision occurs, and both devices stop transmission, wait for a random amount of time, then retransmit. This is the technique used to access the 802.3 Ethernet network channel. This method handles collisions as they occur, but if the bus is constantly busy, collisions can occur so often that performance drops drastically. It is estimated that network traffic must be less than 40 percent of the bus capacity for the network to operate efficiently. If distances are long, time lags occur that may result in inappropriate carrier sensing, and hence collisions. CSMA/CA (carrier sense multiple access/collision avoidance) In CA (collision avoidance), collisions are avoided because each node signals its intent to transmit before actually doing so. This method is not popular because it requires excessive overhead that reduces performance.
A collision domain is an area on the network where two devices may attempt to transmit at the same time. A hub has 1 collision domain overall. A switch has 1 collision domain per interface. The fewer devices in 1 collision domain, the better. ----
No- A VLAN is a single broadcast domain. If the VLAN uses a hub, which essentially connects all devices on a single wire, the the VlAN would be a collision domain. However hubs are rarely seen these days. A network switch keeps every device separated on individual collision domains so every device is kept from colliding with any other device.