Seriously? Raising "pH" and raising "alkaline" is exactly the same thing.
To lower the alkalinity in a pool you can use PH Minus or Muriatic acid. When adding pour into one spot in the deep end of the pool away from circulation, make sure the circulation system is running. Do not apply near metal fittings or near the pool skimmer. Also make sure you follow directions when using the product.ANS2Can't be done. It is like slowing down while you run faster. Lowering the alkalinity is the same as decreasing the pH. The less alkaline the water, the lower the pH.
Alkaline water contains more oxygen than hydrogen, but adding oxygen to the water does not make it alkaline. There are several minerals and natural ingredients one can add to their water to make it alkaline.
Cement is alkaline. However, when mixed with steel (reinforcing bars)(Iron) , which is acidic. they neutralise one another, and so are resistant to weathering.
An alkaline pH is one that is above 7.
In the words of the song, where you are usually depends on where you start. In your case, that means that without knowing the size of your pool and how acidic is is to start with, no one can tell you how much to add to bring it up.
Yes you can but it is quite complicated. First you take a shovel, then you start digging. That should do it. Oh, don't forget to drain the pool before you start diggin, it could get a little muddy. Have fun, Marcy
To lower the alkalinity in a pool you can use PH Minus or Muriatic acid. When adding pour into one spot in the deep end of the pool away from circulation, make sure the circulation system is running. Do not apply near metal fittings or near the pool skimmer. Also make sure you follow directions when using the product.ANS2Can't be done. It is like slowing down while you run faster. Lowering the alkalinity is the same as decreasing the pH. The less alkaline the water, the lower the pH.
you raise me up
No, an acid is an acid and an alkaline is alkaline. They are essentially opposites and will react with one another. The product depends on the specific reactants
Alkaline water contains more oxygen than hydrogen, but adding oxygen to the water does not make it alkaline. There are several minerals and natural ingredients one can add to their water to make it alkaline.
Cement is alkaline. However, when mixed with steel (reinforcing bars)(Iron) , which is acidic. they neutralise one another, and so are resistant to weathering.
Yes, but I was informed not to add more than 2 pounds of baking soda (sodium bicarbonate) at one time. I tried this and it does raise the pH of your swimming pool.
Assuming by "rake" one means skimming the leaves and other debris that floats on the water surface, yes, that should be done first. Some may settle to the bottom during the skimming process. Clean a pool as you would your house ... one dusts first, then vacuum's.
probably more than one second
No, sodium bicarb is used to increase alkalinity. Cyanuric acid is used as a stabalizer. One is base the other acidic.
first one raise in peole.
A US gallon of water is about 8.4 lb, so 30,000 galls is 252,000 lb. One BTU is the heat to raise one pound of water by one degF, so BTU's in your example are 252,000 x 15 = 3,780,000 BTU.