Want this question answered?
guessing is ok when connecting a wire to a front panel header connection. if It doesn't work no harm is done
guessing is ok when connecting a wire to a front panel header connection. if It doesn't work no harm is done
guessing is ok when connecting a wire to a front panel header connection. if It doesn't work no harm is done
9=pins
on the fuse box the blue connector 40 pins is pin 7 or 52 pins is pin 10 , if no wire you need to add.
Hot is positive.
i have a 89 Chevy 2500 with a 350 TBI and the o2 sensor is on the driver side exaust header where the 4 pipes run into 1 from there follow the wire to its harness/connection- i don't believe it has the original passenger exaust header so i am unsure if it comes with an o2 sensor on each side?? happy hunting :)
What happens when the current in the coil is halved? No pins are attracted. ... A magnetic field is always created around a wire when it carries electric current.
Yes. Typically when a component has two wires and they aren't labeled, it doesn't matter which wire is which.
None, the pins are on the motherboard or HDD
It has to be around 6-8 carats, but its near impossible to get the gold out of the pins and wire
The one that is on the back side that looks like a long wire? Pokes thru holes on the pins on each side? In the center there is a hole that the wire sticks into. Get a pair of needle nose pliers and pry it out. Then remove one end that goes into the pin and then the other. Get a good look at it tho or you will spend a few minutes trying to figure out how you got it out.