0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you tighten a clasp on a wallet?
You can use a pair of needle-nosed pliers to tighten the clasp on a wallet. Gently bend the clasp to tighten it against the partner clasp.
Should the ball spin on a hoop ear cartilage piercing?
I assume that you're talking about a captive ball ring. The ball is probably just too loose. Just tighten the ring around the ball by squeezing the ring with pliers. Unless of course you have ring closers. Those are easier to use but pliers do in a pinch. If you don't tighten it, the worst that could happen is that the ball falls out and you lose it. If that happens, you could put a piece of eraser or clay in place of the ball for temporary use.
How do you tighten chain on 2001 polaris scrambler 500 2x4?
In the rear end of machine there is an eccentric that adjust the chain . There are 2 bolts that loosen the eccentric .Loosen the two bolts , loosen the brake collar, a large pair of channel lock pliers works well . Be carful with the greese zert in the middle , use the channel lock pliers and rotate the eccentric to tighten chain . With the weight of the normal rider sitting on the machine you want an inch to an inch and a half play up and down in the middle after you adjust it . Tighten the bolts down and tighten the brake collar .
How do you use pliers in a sentence?
"I used the pliers to cut the wire"
What are pliers classified by?
Pliers are generally classified by their intended use.
How do you tighten a diverter tub spout?
Put a wash cloth or similar over the end and use a pipe wrench or slip joint pliers. The cloth keeps the wrench from scratching the surface of the spout.
What is the use of a long nosed pliers?
They can get in and out of tight spots, unlike regular pliers.
How do you install a sissy bar for a sportster 1200c?
If your installing stock sissy bars and side straps. You will need the following tools: 3/16 " hex wrench and 5/32" hex wrench. Oh! get a 1/2" combination wrench. 1. Remove two button head socket screws and locknuts that hold fender support to fender. Your sissy bar should supply the new screws but save the locknuts. When installing the new screws make sure the steel T-spacers inside of fender are still in rubber grommets before tightening. 2. Position the side strap on fender support and insert supplied buttonhead screws through side strap and fendersupport. Use the OEM locknuts removed in step 1 on screws and tighten to 8-13 ft.-lbs. 3. Repeat steps 1 and 2 for the other side. 4. Install the sissy bar to the side straps and tighten with the four buttonhead screws supplied with kit. That sums it up... Jaime G.
How to tighten a handbrake?
underneath the centre console is a clamp in the clamp should be your 2 brake cables that control your handbrake ...you can tighten them there ...use spanner as is a squeeze to get a socket on
Do you use needle nosed pliers to put on broadheads?
There are several cheap and effective tools to tighten broadheads. You can usually find them at any store selling archery supplies. Using needle nose pliers will work but you have a good chance at damaging the blades or bending them which could affect the flight and accuracy. The tool is cheaper than a new blade.
Who uses pliers?
All technicians, electricians, plumbers and handymen use pliers almost every day.
Black worms in bathtub?
Too bad!You will have to wash tub and scrub it with soap. Use Borax.You should pick out the worms with pliers!
