It will be one of the smooth ones with no ribs.
You don't. The pulley is pretensioned by the manufacturer. If the belt tension is incorrect, the pulley must be replaced.
there is one blot that attaches tension pully to block this holds the whole configuration ,on not just the pulley. buy a new one and you will see how it is manufactured, u will then know exactly where the bolt is that holds it on
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
put it on the tension srewand push back towards muffler
The tension pulley should have a bolt that holds it on, allowing you to replace the unit.
tension pulley is an automatic tensioner that keeps the serpentine belt at the proper tension it is a single pulley that is smooth (no grooves) usually turning clockwise with constant pressure loosens pulley for belt removal use caution pulley is spring loaded
you dont adjust a tension pulley you adjust the position of the compressor to tighten the belt
u need to relaese tension on the tension pulley. this is usually done with a long socket wrench handle. when u release tension and remove belt you then release tension on pulley until you have routed new belt . you then move tension pulley again until you can put belt on it, then release pulley and it will automatically provide correct tension
It probably has a tension release pully, not a bolt. The pully has no function except tension. Your repair manual probably has instructions on changing the belt and a photo of the small pulley. Mary
The tension pulley is centerline with the engine and at the very top of the belt routing.
Most cars now have a serpentine belt that drive the alternator, water pump, power steering unit, etc. The belt tension pulley is a spring loaded pulley that keeps the proper tension on all these units. It can be moved to release the tension in order to remove the belt.
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.