0
What else can I help you with?
How do you replace a tension pulley on a 2001 Lincoln town car?
Disconnect the battery.remove the serpentine belt.Unbolt the pulley.
Replace a pulley on a 99 Lincoln continental?
purchase a pulley remover and installer tool, then write baack when you have it.
How do you replace a tension pulley on a dodge truck?
The tension pulley should have a bolt that holds it on, allowing you to replace the unit.
How do you replace the tension pulley on 1998 Old Regency?
To replace the tension pulley on a 1998 Oldsmobile Regency, start by disconnecting the negative battery terminal to ensure safety. Use a wrench to relieve tension on the serpentine belt by turning the tensioner pulley, then remove the belt from the tension pulley. Unscrew the mounting bolts securing the tension pulley and replace it with the new one. Finally, reinstall the serpentine belt and reconnect the battery terminal.
On a 96 Lincoln Continental How do you place the belt around the tension pulley?
there is a special took that you can purchase that you have to insert into the tensioner and pull it up slowly and take off the belt, do the reverse to put it on
How do you replace the idoler pulley on my Nissan 1996 200sx 1.6?
replace 1996 nissan 200sx se 1.6 tension pulley
Loosen tension on serpentine belt on a 2000 jeep Cherokee sport?
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
Can't loosen idler tension pulley on air conditioner idler pulley?
Replace the tensioner assembly as one piece.
If the tension pulley is bad on a 91 2.2 l Corsica can one just replace the pulley or must one replace the entire assembly?
Call the parts store. They will be able to tell you if the pulley is available separately or not.
How do you move the tension pulley?
There should be a "square" cut into the pulley bracket that fits either a 1/2 inch or 3/8 inch ratchet or breaker bar to allow you to remove tension from this pulley allowing you to replace the serpentine belt.
How do you change the tension pulley and serpentine belt on a 1994 Lincoln mark viii?
I used a breaker bar for the tension pulley to relieve the tension to remove the belt, I think there are three bolts that hold the tension pulley on, just remove them and reverse the procedure to install. Follow the diagram that is either on the inside of the hood or on the radiator cover on how to thread the belt back on the pulleys.
How do you replace the serpentine belt tension pulley on a Buick Regal?
with a 9/16 socket and ratchet
