0
Both sides. On the exhaust.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change an oxygen sensor on a 1981 ford ltd crown Victoria?
The 1981 Ford Crown Victoria does not have an Oxygen sensor.
Where is the oxygen sensor located on a 1997 Ford Crown Victoria?
There are 4. Two before the cats and two after.
Were is the bank 2 downstream oxygen sensor located on 2002 ford crown Victoria?
On a 2002 Ford Crown Victoria : Bank 2 is the drivers side of the engine Sensor 2 ( downstream sensor ) would be in the exhaust after the catalytic converter
Where is the DPFE located on a 2002 ford crown Victoria?
where is the DPFE sensor located on a 2002 ford crown victoria?
How many o2 sensor does a 89 Crown Victoria have?
There are two oxygen sensors on a 1989 Crown Victoria. One is located on each of the exhaust pipes coming off the exhaust manifold.
Cam sensor ford crown Victoria?
where is the cam sensor located on a 2003 ford crown vic
Where are the oxygen sensors located on the Crown Victoria?
By the air filter, the tube that comes from the air filter box has a small wire connection, that will unplug showing the 02 sensor
1995 ford crown Victoria how to repair crank sensor?
2002 ford crown Victoria how to repair crank sensor?
Where is the intake temp sensor located in 1989 5 liter Ford crown Victoria?
on top of the intake
Where is the knock sensor located on a 1996 Crown Victoria?
It is located on the side of the engine block. If you have a code for a knock sensor and you have a noise in the engine, it will set the code. That does not mean that the sensor is bad. They very rarely give problems.
Where is the cooling Fan temperature sensor on a crown vic?
coolant fan temp sensor 1998 crown victoria
How do you replace 94 Crown Victoria transmission position sensor?
The transmission position sensor on the 1994 Crown Victoria can be replaced by first disconnecting the battery. The transmission sensor is located on the driver's side of the outer casing to the transmission. Unplug the old sensor and plug in the new one, then connect all of the wires to the new sensor, one by one. Then reconnect the battery.
