0
Which statements is correct concerning the default configuration of a new switch?
Wiki User
∙ 8y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is there default pin code for a garmin nuvi 250w?
1234 is the Nuvi default pin
What is the default vtp mode on a catalyst switch?
TransparentTransparent is a bit iffy..? By default, a Catalyst switch is in the no-management-domain state until it receives an advertisement for a domain over a trunk link or until you configure a management domain. However, the default mode is Server mode.
Why does Haiti have so many earthquakes?
Because they are on a default line
Why are females considered the default sex?
because, genetically, we have weaker genes
What is the default VTP Mode of operation for all Cisco catalyst switches?
2
Which three statements are correct concerning the default configuration of a new switch?
It is configured in VTP server mode. STP is automatically enabled. All switch ports are assigned to VLAN1.
Which type of printer configuration method overrides any other type of configuration?
Default
Where are the details for a complex Linux configuration found?
Default
What is the default configuration register setting for a cisco router?
0x2102
How do you set Firefox to online default configuration?
Online default configuration is not very relevant a question. If you want to set Firefox as your default browser then go the top menu in Firefox. click tools ->options ->advanced ->general Tab ->Always Check to see if firefox is default browser ( tick this option)
What is reset botton in router?
The reset button in a router let you remove all the configuration you do and gives you the default configuration from factory.
Which default EIGRP configuration must be modified to allow a router to advertise sub-nets that are configured with vlsm?
Which default EIGRP configuration must be modified to allow an EIGRP router to advertise subnets that are configured with VLSM
What tcp ip configuration specifies the address of a router?
The "default gateway" is your router.
What is the default sequence for loading the configuration file on a router?
NVRAM, TFTP,Console
Multiple default statements in switch statement in c?
I really think this is not possible.
IDE and EIDE hard drives are usually set to be in what configuration by default?
Single drive
What steps must be taken to remove the changes and return the router to the default configuration?
Reload the device.
