0
What are my choices?
Wiki User
∙ 15y ago
Wiki User
∙ 13y agoCrimper
Add your answer:
Earn +20 pts
What tool do you use to make sure a cable has been crimped?
cable tester
What tool would you use to create a twisted pair cable?
Cable tester
What patch cable is normally used for connecting hubs?
Unless your hub has a switchable port, you use a crossover cable.
What is the function of crimping tool?
is a tool use to crimp or connect a connector to the end of a cable..
What tool does one need to cut a heavy-duty cable?
To cut a heavy duty cable you can use a tool made by Klein tools called a Ratchet Cable Cutter (10 inch). This tool is sold at Graingers and cost about 326.00.
What kind of workers would use a cable locator?
People that install cable or other electrical wire would be the kind of workers that use this kind of tool. Utility companies all have these locators to make their job easier.
Which tool can you use to determine the distance to a fault in a faulty cable?
Time domain reflectometer
How to Punch Down a Patch Panel of Any Size?
Patch panels are an inexpensive way to allow easy access to your networking cables. There are many manufacturers that make them, and there is a standard on how the panels are punched down. For instance, every panel has color-coded slots on the back to insert the individual wires in. Should have a place to write down information for each jack on the panel itself. Remove the backboard from the panel, and mount the panel upside-down on the panel to help keep it in place. Use cabling scissors or a RJ45 crimping tool to strip the sheath off one of the cat5e cable and the white string. Use only about an inch of each of the twisted-pair cables. Unwind the cables slightly while keeping the twist as tight as possible, then press each individual wire via color code into the slots on the panel with your fingers. After the wires are in place for an individual cable, use a standard punch tool (available at most hardware stores) to install the wires. Simply press down the slot with the tip of the punch tool, then press down hard with the tool. A “punching” sound should be made as the tool presses the cable tightly into the slot. The punch tool has a blade that cuts off the excess wire as it is being pressed into the slot. The slot itself will create a small cut in the wire insulation to allow the metal wire to have contact with the panel. Repeat these steps for all eight wires in the cable. After all of the cables have been installed in the panel, place the front of the panel back into the backboard. Now it is time to test each jack of the panel to make sure the cables are installed correctly. Plug a cable tester into one of the jacks on the panel. Plug the other end of the punched cable into the other module of the cable tester. Test the cable as stated on the instructions of the cable tester. Cable testers are similar in the way each one operates, and they are not difficult to read. Repeat these steps to test each jack of the patch panel. And now you’re done!
What is the difference in Ethernet crossover and patch network?
tpatch cable is also known as straight cable and mostly connected same devices or nodes. but on the other side cross cable is just different then patch and used to connect different devices. Hem Gurjar
What tool would you use to verify that your cable meets Cat 6 standards?
A. Continuity Tester
What tools can you use to remove blemishes in an image on Photoshop?
Spot Healing Brush, read article on related links There are many tools you can use: The Clone Stamp Tool, The Spot Healing Brush (as mentioned, above), The Healing Brush Tool, and the Patch Tool.
How do you lube a noisy speedometer cable on a 1985 Olds Ctulass?
you can buy a tool made for lubricating cables, at a motorcycle shop then u need to disconnect the cable from back of speedo, use the tool and lubricant then reintall cable to speedo usually tho if a speedo cable gets noisy it is worn out and about to break
