In an application of pressure reduction, the warm up valve (bypass valve) is used to warm the steam line, within recommended time frames, before the control valve is placed into operation. A steam control valve should not be used for warm up of a steam distribution line.
Stop Boiler Valve (or Crown Valve) is installed on an outlet line of a boiler. It's purpose is isolation of a boiler from a downstream steam line. Its position may be either open or close, it cannot be used for throttling of steam.
how to calculate gate valve torgue. What is the torgue required for 1100NB gate vave used for 3kg/cm2 steam line
It is a stop valve placed on an auxiliary piece of equipment. Or it could be placed at the steam main to feed an auxiliary steam system (heating, auxiliary pumping. etc.). It is not the Main steam stop for the boiler or the prime mover (engine, turbine, process), it is for a secondary service.
to let the steam pass and avoid an explosion under some undesireable circumstances.
For a steam engine, the steam(throttle) valve that sets the engine speed/power is often known as a regulator. k.Shiva
In an application of pressure reduction, the warm up valve (bypass valve) is used to warm the steam line, within recommended time frames, before the control valve is placed into operation. A steam control valve should not be used for warm up of a steam distribution line.
Stop Boiler Valve (or Crown Valve) is installed on an outlet line of a boiler. It's purpose is isolation of a boiler from a downstream steam line. Its position may be either open or close, it cannot be used for throttling of steam.
You use Steam by valve.
The function of steam stop valve to supply steam to steam maniform and the function safety valve to prevent the steam high pressure over.
Used in power generation. When steam turbine is on-line the Main Steam Stop Valve is fully open. When offline it is closed. Steam to turbine is controlled thru control valves after Main Steam Stop Valve
diaphram valve
how to calculate gate valve torgue. What is the torgue required for 1100NB gate vave used for 3kg/cm2 steam line
It's probably valve. The valve team also has steam. Inside steam you can use the level/map editor to design a new map with stuffs!
never
Athrottle valve controls the flow of steam to the engine. Without throttling the steam the engine will simply run full speed and vary in speed as the load increases and decreases. The throttle valve maintains a steady speed by opening as the load increases and closing as the load decreases.
The purpose of a steam trap is to stop steam from passing beyond its point of use. A steam trap performs two functions. One is that it is an air vent. Two, is that it is a water outlet valve.