You know, I really don't think it makes a difference what way you thread it, as long as it keeps your pants up! =D
I never threaded the belt thru the pads.. i would imagine it would be difficult to thread the pads and pants. they make an underwear type thing that fits tight to the skin like spandex and has pockets to hold the pads. Any sports store would have them. this is what I would suggest. however it is possible to thread the pads and belt, but not very functional or comfortable. As I have never done I can not say the best way to accomplish it. The pads do not get threaded with the belt. I have found the best way to thread the belt is to attach a large safety pin to the tip of the belt. Then insert the pin into the belt opening in the pants. ( I turn the safety pin around so the elbow end goes into the pants first). Then slowly thread the pin thru the pants and it will pull the belt with it.
You're not meant to. It's a way for the caterpillar to get down safely, and if you break the thread the caterpillar will fall and get injured. Another reason they might be hanging from a thread is they are about to spin their cocoon to turn into a butterfly, and if they drop down at that moment they might not make it to their adult form at all! Leave them be and enjoy them, in both forms. ^^
Remove serpentine belt and have new tensioner ready, look at it the bolt holding it to the block may be lefthanded thread usually 18 mm. Mosy gm parts are bolted on with metric so try to take it off with left handed thread (clockwise first) if that isn't it then do the normal way put belt back on. A belt tensioner tool is a good investment. they ar eat autozone and cheap and make the job a 5 minute task
Anti clockwise is a normal bolt removal procedure. Does it have an "L" stamped on it? - meaning it's a left hand thread and removal is clockwise.
They were being plucked. It's an Indian way of doing it. Meant to be totally painless and last longer than plucking with tweezers.
normal thread is used, the thread used in Tailor work. It is just the way they use it, it seems magic.
pulley has left hand thread so go clockwise to remove
yes
Thread- as used to mean sewing thread, or thread cloth is woven from- was made in pre-historic times. The spinning of thread and weaving of cloth is older than writing- so there is no way of knowing who did it first. Sorry.
The Way Life's Meant to Be was created in 1981.
Comprssor bolt will be in your way so you have to take that off. I take both mounting screws off and the belt comes off. You have to get the ac belt off there , so to do that you just cut the belt with a knife. Then there is no way of loosening the compressor, so what you have to do is loosen the pully wheel. It will be located under the power steering pump. Then all you have to do is slide that pully wheel down the slotted adjuster mount. Then you have to jack the motor up and loosen the engine damper mount and slide a new belt arount the mount. (If you want to take the belt off with out cutting it you will see what I am talking about). It has to be around the mount, and the mount is inside the loop of belt. Thread up the adjustable pully, compressor and drive wheel on the belt. and then Tighten the belt. When the tension is on the belt tighten the nut on the pully. check for the proper deflection.
Generally speaking, the term or phrase bedroom eyes is a way of saying someone is interested in having sex. It comes from the look of seduction given by both males and females when they are aroused.