They only go on one way.
There is two screews that hold the cap on ,remove them. Then just pull the rotor up and off. It will only go on 1 way. Transfur wires to new cap while keeping them in order.
Firing order is 1-8-4-3-6-5-7-2. Move #1 cylinder to where piston is up, and on the compression stroke (TDC). Easiest way to do this is with a compression tester on the #1 cylinder - rotor cap OFF. When you see the pressure build...you're on the compression stroke. The rotor cap should be at the #1 cylinder firing position...simply re-install the rotor cap at this time - noting which button is #1. Starting at #1 install the wire for the #1 cylinder onto the rotor cap...the next button (clockwise) on the cap should correlate to #8; the third button on the rotor cap is, cylinder #4..and so on. work your way around the rotor cap until you have all 8 cylinder wires in place...ignition coil wire in the middle button. Engine should start and run.
Because without a tail rotor the body of the helicopter would spin the opposite way of the main rotor so the tail rotor is perpendicular to prevent that : Way it works is the tail rotor spins at the same speed as the main rotor to over power the body's need to spin by giving just the right amount of need to go the other way : Hope I Helped , jd703
press the same button
i take karate and you are supose to use your hips to go higher
YESS!!
go staight up once youv'e stoped go right then go down and up to the next button then take a right and go up and battle the women then go on to the next room. then go to the blue button press it again and again then get off and go on the bridge battle the nerd. then go to the blue button then over to the green one go down the to the left up the stairs then on the bridgeif you want to battle the kid you can. go threw the door go up to the red button then go down go to the next walk way press the button and go down and go onto the bridge then battle the guy press the button then you should find your way through there
dally uses the switchblade that he got from two-bit to threaten the nurse so she would let him go
The rotor will only fit in one way. Install it how it fits in and you should be good to go.
its ok i supose but i wouldnt go cos u know its just like england
Two buttons Ctrl + hold down Ctrl button and press + also to go the other way is Ctrl with - button to return to normal is Ctrl with 0 number
Rotors can only go in correctly one way and will usually snap in place. If you manage to put one in backwards the car will not start and it will likely tear up the cap and rotor.