Yes it is. The term "sending unit" is misleading since it actually doesn't send anything. It's a receiver of sorts and provides a "variable ground" for the gauge in the dash to put it simply. There is a rheostat in the sender that effectively changes the voltage allowed to pass through the sending unit to ground as the float moves up and down with fuel level in the tank.
The pulsations are caused by the voltage limiter in the dash that limits the voltage powering up your gauges ( and in turn going to your senfing unit. This limiter acts in a fashion like your flashes. It pulsates the current (turning it off and on) at a rate that never allowing the voltage to go over a cretain limit. This pulsation also SOME WHAT allows the gauge to hold a steadier reading as the fuel sloshes around in the tank causing the float to rise and fall rapidly. Consider it an electrical trick to average the fuel level over a length of time. I doubt though that the factory engineers designed it with this in mind.
Flow control
http://support.microsoft.com/kb/923200 When the sending computer sends FIN, the state of the TCP connection is set to FIN_WAIT_2. After the TCP connection has been closed, the sending computer sends RST in order to reset the connection if the receiving computer sends any packets to the sending computer.
It does not take a long time to use a fax service. It usually depends on the connection between the place where you are sending it and the person's connection who is receiving it.
Session Software
Using varying bit ratesUsing two pairs of twisted-pair cableUsing sending and receiving modems
Sharp bending, cable pinch, spyware, worm virus, sending or receiving of large email, streaming.
E-mail enables the sending and receiving of files.
I will doubt the connection or the sending unit. Hope this will help.
It can vary depending on the internet connection that the sending and receiving parties have, but generally no more than a few minutes.
Yes, a fax is capable of sending and receiving messages from another fax machine.
sending and receiving messages
sending and receiving messages