* Relieve the fuel system pressure * Disconnect the negative battery cable if car is equipped with Delco-Loc 2 or Theftlock audio system make sure you got the activation code first * Remove the fuel tank Disconnect the fuel pump/sending unit harness connector and the fuel tank pressure sensor from the fuel tank * The fuel pump/sending unit assembly is located inside the fuel tank.Using a pair of snap-ring pliers contract the retaining collar and remove the top of the fuel pump assembly * Lift the fuel pump/sending unit assembly from the fuel tank * Inspect the condition of the O-ring around the opening of the tank if its dried,cracked or deteriorated replace it * Remove the strainer from the lower end of the fuel pump.If its dirty,clean it with a suitable solvent and blow it out with compressed air.if too dirty replace it * Remove the fuel pressure sensor mounting bolts and separate the sensor from the top of the fuel pump assembly * If it is necessary to separate the fuel pump and sending unit,disconnect the electrical connectors at the pump,noting their postions * Disconnect the fuel line from the pump
Drop the fuel tank. It is in there.
It is located in the gas Tank. in the gas tank
No, the fuel tank must be removed to access the fuel pump.
If your looking for an inertia fuel switch, it doesn't have one.
in the fuel tank.
If a 1996 Chevrolet Cavalier will not start, it could very well be the fuel pump. It could also be the starter or battery.
in the tank
The 1984 Chevrolet Cavalier 2.0 liter engine fuel pump relay can be found on the firewall in the engine compartment. The fuel pump relay will be on the drivers side of the firewall.
frame rail
Mounted on top and inside the fuel tank.
Chevrolet does not use inertia/reset switches.
Chevrolet does not use inertia switches.