The dryer is a 240v dryer so two of the wires are your hot wires, or the ones with power on them. One is your ground wire. And the forth is your neutral.
If you are no longer using the dryer and there are 4-wires, and the dryer was 220 to 240 volts, it can be split into two 110 to 120 Volt circuits.
Green is ground and white is neutral.
It may be a 220 Dryer, and you will need a new outlet installed. There should be no extra wires when connecting the Power cord to the plug
There is no configuration with that amount of wires. Proper connection requires three wires and a ground.
in back of dryer u should have a block with three wires 2 blacks 1 green the one u are trying to wire up should have 2 black 1 green 1 white the white and green wire go in the midle post of the block on the dryer and the other 2 wires go to the out side posts of the block
If you are no longer using the dryer and there are 4-wires, and the dryer was 220 to 240 volts, it can be split into two 110 to 120 Volt circuits.
How do the wires connect on a 3 prong electrical cord on the lde8414ace maytag dryer
Green is ground and white is neutral.
It may be a 220 Dryer, and you will need a new outlet installed. There should be no extra wires when connecting the Power cord to the plug
There is no configuration with that amount of wires. Proper connection requires three wires and a ground.
in back of dryer u should have a block with three wires 2 blacks 1 green the one u are trying to wire up should have 2 black 1 green 1 white the white and green wire go in the midle post of the block on the dryer and the other 2 wires go to the out side posts of the block
On a 3 wire dryer cord there is no green wire. The white wire coming from the outlet is connected to ground or the green screw. The black and red wires are the hot wires.
To answer this question correctly the number of wires in the existing cord is needed.
The heat can travel by the air/oxegyn.Electric can go by the wires/energy.
A four blade dryer plug cord should have a red, black, white, and green wire in the cord set. The red and black wires are the ones that deliver the 240 volts to the dryer. Black and white deliver control 120 volts to the dryer and also drive the motor to turn the dryer drum. On some dryers they use the red and white for the motor and black and white for the control. As for the green it is always the ground wire.
Dryer plug three to fourOpen up the electrical access panel on the back of the dryer. You will see a terminal block with three wires going into it from the plug cord assembly. A red and black and white are now connected to the terminal strip. Look at the position and colours of the existing 3 prong cord and how it is connected. Make a diagram. Coloured wires on the outside terminals white in the center. From the center wire terminal you will see a jumper strap that goes to the frame of the dryer. When installing the four prong plug this jumper is removed completely. The kit should have with it a grounding lug that connects to where the removed grounding strip attached to the frame of the dryer. This is the attachment point for the fourth green ground wire from the new dryer cord assembly.
Have the outlet changed to match the configuration of the dryer plug.