It could simply be a bad catalytic converter. I have seen this cause a lack of oil pressure. Have a mechanic check it, or if you don't care, chop it off with a sawzall and see if it runs.
Trouble code P0944 means: Hydraulic pressure unit loss of power
Trouble code P1391 means: Intermittent loss of CMP or CKP
If the engine restarts it is probably not an oil issue. The oil pressure will go to 0 after the engine shuts off. You need to check for loss of fuel or spark when it dies off.
Low oil level, diluted oil, faulty pressure sensor, plugged oil filter, failed oil pump, internal engine failure.
Turgor pressure
Pregnancy after a loss was created in 1999.
no you can not
It is a small spark plug looking thing wired to dash that senses a loss of oil pressure and trips the light usually somewhere on crankcase.
Did you check for compression loss? or Is the catalytic convertor blocked?
The system has pressure on it but the switch can be screwed off. A schrader valve prevents the loss of refrigerant. Install the new one after you have put some Air conditioning oil on the O ring seal.
Usually, a loss of pressure in your brake system means that there is a hole somewhere in the system. A leaking brake line or a punctured reservoir could cause a loss of pressure. A bad master cylinder could also cause a loss of pressure in the back brakes.
No.