0
What else can I help you with?
Why transistor is called so?
transistor. This word is a blended form of transfer of resistor. The legs of transistor (collector, emitter,base) transfer the resistance. So it is called as transistor
What is direct couple transistor logic?
Direct coupled transistor logic is a type of transistor that is more economical to use then integrated circuits. These transistors can be found in many types of wires such as the ones that control cable internet.
What are Ac load lines in an amplifier and how they are drawn?
The dc load resistance is Rc but the AC Load resistance is (RcRl). If a load line is drawn the slope of which is -1(Rc Rl) . Then it is called an AC load line and it is to be used when the transistor is operating as an amplifier.
Why transistor is called as bi-polar device?
Transistor is called Bi-Polar device because the current can be flow due to electron and holes, hence it is called bipolar.
Why transistor is called transfer of resistor?
Transistor=Transfer+Resistor. When Transistor operates in active region its input resistance is high and output resistance is low. So,We can consider transistor as a device which transfers its resistance from high to low. And by this property transistor amplifies input signal.
Why does your RC car go backwards on its own?
Open up the case and replace the B772 transistor on the circuit board.
What is unmodulated signal from a transistor is called?
When the out from a transistor is the exact replic of the input signal then it is called unmodulated signal i e. there will not be any change in frequency voltage power etc
Phase-shift oscillator using pnp transistor?
A phase-shift oscillator using a PNP transistor consists of an RC network in the feedback path, a PNP transistor biased to operate in the active region, and a network of resistors and capacitors that provide the required phase shift for oscillation. The RC network introduces a 180-degree phase shift at the desired frequency, and the transistor provides the additional 180-degree phase shift needed for sustained oscillation. By properly selecting the values of resistors and capacitors, along with biasing the transistor correctly, a stable sinusoidal oscillation can be achieved.
What can the input of a transistor be called?
The input of a transistor is typically referred to as the "gate" in a field-effect transistor (FET) or the "base" in a bipolar junction transistor (BJT). In both cases, the input controls the flow of current through the transistor, allowing it to function as a switch or amplifier in electronic circuits. The gate or base receives the input signal that modulates the transistor's operation.
Why a transistor is called with BC547?
A small signal NPN transistor used for general purpose audio amplifiers and switching.
What are the instruments for the study of the gain of a two stage RC Coupled transistor amplifier?
depends on whether you would like calculate or measured results. if you want calculated resulted, then your best bet would be to use an oscilloscope. if you want calculated results, then there are formulas for finding out the voltage, current, impedance, and individual results from each component using the capacitive reactance, voltage, and type of transistor. are you using a summing transistor, inverting amplifying transistor, amplifying transistor, or a different transistor? also are you using DC or AC voltage or current? you need to tell me what type of transistor you are using?
What are transistor connections called?
Transistor connections are commonly referred to as terminals. For bipolar junction transistors (BJTs), the three terminals are called the emitter, base, and collector. In field-effect transistors (FETs), the terminals are called the source, gate, and drain. These connections are essential for the transistor's operation in amplifying or switching electronic signals.
